Kruger Matz KM0945 Electronic Bike Horn Owner’s Manual
- June 4, 2024
- Kruger Matz
Table of Contents
Kruger Matz KM0945 Electronic Bike Horn
SAFETY INSTRUCTIONS
Read this instruction manual and keep it for future reference. Producer does not take responsibility for damages caused by inappropriate handling and use of the product
- Producer of this product is not responsible for damages/injuries caused by inappropriate handling and using of the device.
- Do not throw the device into fire. Explosion hazard.
- Do not use this device if it has been damaged.
- Do not expose it to direct sunlight and other sources of heat.
- In case of damage, contact authorized service point for check-up or repair. Fixing this device on your own may lead to damage and voiding the warranty.
- While charging, the device may heat. This is a normal.
- Protect this device from water and other liquids.
- Do not point light beam directly at eyes.
- Clean the device with soft, slightly damp cloth, without abrasive agents.
PRODUCT DESCRIPTION
- Speaker
- Charging socket
- Increase volume button
- ON/OFF button
- Volume decrease button
- Turn on the horn button
- Change the horn button
OPERATION
Installation
Mount the speaker to handlebar, or another part of bike in a way that it points forward. The pilot has to be mounted as close as possible to the place, where you place your hand during ride.
Horn
- To power on the horn, press and hold the ON/OFF button. The horn will emit a single beep. Now it is ready to use.
- To use the horn, press the horn button.
- To change the horn, press the change horn button.
- To change the volume of the horn, use the volume increase and decrease buttons. After each press, the horn will beep, indicating current volume level. After reaching minimum or maximum level of volume, pressing the button again will not indicate volume level.
- To turn off the horn, press and hold the ON/OFF button.
Charging
- If the sound of the horn is weak, the battery has to be charged.
- Connect provided microUSB cable to the charging socket (placed under the rubber cap). Connect the other end of the cable to a power adapter.
- Charging will be indicated with an LED next to the charging socket.
- If the LED glows red, the horn is charging.
- If the LED glows green, the horn is charged. You can disconnect the cable.
SPECIFICATION
- 4 horn sounds
- 5 volume levels
- Handlebar mounting
- Charging indicator
- Loudess: up to 100 dB
- Protection class: IP65
- Battery: lithium-ion / 3,7 V / 280 mAh
- Charging time: approx. 1,5 hours
- Cable length: 40 cm
- Material: ABS + PC
- Weight: 44,5 g
Correct Disposal of This Product
(Waste Electrical & Electronic Equipment)
(Applicable in the European Union and other European countries with separate
collection systems) This marking shown on the product or its literature,
indicates that it should not be disposed with other household wastes at the
end of its working life. To prevent possible harm to the environment or human
health from uncontrolled waste disposal, please separate this from other types
of wastes and recycle it responsibly to promote the sustainable reuse of
material resources. Household users should contact either the retailer where
they purchased this product, or their local government office, for details of
where and how they can take this item for environmentally safe recycling.
Business users should contact their supplier and check the terms and
conditions of the purchase contract. This product should not be mixed with
other commercial wastes for disposal.
Made in China for LECHPOL ELECTRONICS Sp. z o.o. Sp.k., ul. Garwolińska 1,
08-400 Miętne.