Anolis AMBIANE SP16 Recessed Tiltable LED Lighting Instruction Manual

Anolis AMBIANE SP16 Recessed Tiltable LED Lighting

INSTALLATION INSTRUCTIONS

AMBIANE SP16 RECESSED TILTABLE

• The unit must be installed by a qualified electrician in accordance with all national and local electrical and construction codes and regulations.

STEP 1 CEILING OPENING

• Prepare mounting hole with diameter of 115mm.

STEP 2 CONTROL UNIT MOUNTING

• Place control unit above the ceiling.
• Mount the control unit to ceiling via two mounting holes and suitable fasteners.

STEP 3 PREPARE CONNECTION

• Shorten power/data cable to required length.
• Strip these lengths of cable for wiring connection.

STEP 4 PRIMARY POWER CONNECTION

• Install terminal block to power cable (from Ambiane Power Rack or Ambiane Power AP) and connect it to Primary power socket of the control unit

STEP 5 DATA (DMX OR DALI) AND SECONDARY POWER CABLES CONNECTION

• Install terminal blocks on SECONDARY POWER and DATA cables and connect them to the control unit. Set the DIP switches to positions according to your operation mode.
• The fixture can be controlled by DMX or DALI (switch 11 in OFF position).

STEP 6 LED UNIT CONNECTION

• Pull the cable through the hole. Install terminal block on LED unit‘s cable and connect it to the control unit.

STEP 7 AMBIANE MOUNTING

• Lift up spring clips on both sides. Insert luminaire into ceiling opening.
• QRelease spring clips to hold lumaire in place.

ROBE lighting s. r. o.

• Palackeho 416
• 757 01 Valasske Mezirici
• Czech Republie
• Tel.: +420 571 751 500
• E-mail: info@anolis.eu
•  www.anolislighting.com
• VERSION 1.0 / 10_2023

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>