AUTOUTLET DTI Digital Dial Indicator Fractions Instruction Manual
- June 14, 2024
- AUTOUTLET
Table of Contents
AUTOUTLET DTI Digital Dial Indicator Fractions
Nomenclature
- Contact point
- Spindle
- Mounting diameter
- ON/OFF switch(M button)
- Zero-setting
- LCD display
- Data output interface
- Anti-dust-cap
- Battery compartment
- in/mm switch
- Back cover
Function
- Zero setting at any position.
- Inch/Metric system interchange at any position.
- With two type data output interface: normal or mini-USB interface.
Specification
- Resolution:
- digital indicator: 0.01 mm/0.0005″
- digital micro-indicator: 0.001/0.00005″
- Measuring Range:
- digital indicator: 0-12.7mm/0.5″, 0-25.4mm/1″
- digital micro-indicator: 0-5mm/0.2″, 0-12.7/0.5″, 0-25.4mm/1″
- Power: One sliver oxide battery(SR44) work with voltage 1.5V
- Operating temperature: 0 °C-40 °C
- Storage temperature: -20 C-70 C
- Relative humidity: 580%
Use Step
- Clean the contact point and spindle with a soft cloth before using.
- Press the ON/OFF switch. The 0.00mm display appears, and the indicator is ready for measurement.
- Inch/Metric system is interchanged by inch/mm button.
The method of replacing battery
Remove battery compartment lid and replace the SR44 battery with its positive(+) side facing upward.
Important
- The response speed:50.5m/s.
- Avoid shocks, impact, dropping etc, otherwise it will damage the appearance and precision.
- Keep indicator face clean, prevent liquid from getting into inside.
- Do not remove output connector lid without using output interface. Output end should never be connected with metal or it will damage the indicator.
- Do not connect any part of digital indicator with voltage, otherwise it will the circuit of indicator.
- Must be taken out the battery if not in use for a long time.
FAQ
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>