LS-88 ListenIR Portable System User Guide
- June 14, 2024
- LISTEN
Table of Contents
LS-88 ListenIR Portable System
How to Set Up
Your Portable ListenIR System Comes with the Following Products
- LT-84 ListenIR Transmitter/Radiator Combo
- Power Supply
- Tripod
- Microphone
- LR-4200-IR iDSP Receivers
- Universal Ear Speakers
- Neck Loop/Lanyards
- 4-Port USB Charger
- USB to Micro-USB Charging cables
- Assistive Listening Compliance Sign
- Portable IR Carrying Case
Transmitter & Microphone Set-Up
- Step One: Remove the LT-84, power supply, tripod and microphone.
- Step Two: Screw the tripod into the bottom of the LT-84.
- Step Three: Plug the power supply into the back of the LT-84.
- Step Four: Plug the microphone into the back of the LT-84.
- Step Five: Plug power supply into an outlet. Turn on power switch.
- Step Six: Make sure the microphone is placed close to the sound source.
- Step Seven: Turn the volume all the way up.
PRO TIP: Make sure that the LT-84 is not concealed behind walls, curtains, or treated glass, as Infrared light needs a clear line-of-sight to the receiver for the best performance.
Listening with the iDSP IR Receiver
- Step One: Plug the Neckloop/lanyard into both audio jacks on the iDSP IR receiver.
- PRO TIP: Make sure your iDSP IR Receiver is worn on the outside of clothing for the best performance.
- Step Two: For Listeners Using Ear Speakers: Plug the ear speaker into the audio jack two thirds up the Neck loop/lanyard, then place the Neck loop/ lanyard around the listener’sneck, and the speaker on the ear.
- For Listeners with Telecoils: Telecoil users do not need an ear speaker. Place the Neck loop/lanyard around the listener’s neck; it will interact with the listener’s telecoil.
- Step Three: Turn on by holding down the power button for one second; turn off by holding down for three seconds.
- Step Four: Adjust volume with the volume buttons on the front of the receiver.
Charging your iDSP IR Receiver
There are two ways to charge your iDSP IR Receiver.
- Option One: Use the 4-Port USB Charger and USB to Micro-USB charging cables. Insert the charging cables into the receiver and charger, then plug into an outlet to charge.
- Option Two: Use the USB to Micro-USB charging cables with your PC. Insert the charging cables into the receiver, then plug into the USB on your computer.
PRO TIP: It is best to let the receivers charge fully between each use.
Contact
LISTEN TECHNOLOGIES
- 14912 Heritage Crest Way, Bluffdale, Utah 84065-4818 USA
- Phone: +1.801.233.8992
- Toll-Free: 1.800.330.0891
- www.listentech.com
Copyright © 1998 – 2022 Listen Technologies Corporation. All rights reserved. 20221017.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>