ZOSI F920000 8 Channel Outdoor CCTV Camera System Instruction Manual
- June 14, 2024
- ZOSI
Table of Contents
ZOSI F920000 8 Channel Outdoor CCTV Camera System
Mounting the Camera
The camera can be mounted onto a flat, vertical surface using screws. The surface must have sufficient strength to hold the camera. Materials such as hardwood, brick or masonry are good options, You can mount the camera onto a metal surface, but you’ll need to supply your own mounting hardware.
Positioning the Cables
-
When running your cable, try to avoid bending it at sharp angles.
-
Don’t put your cable near live electrical wiring.
AC electricity generates radio “noise” which can interfere with the signal from your camera. -
AII wiring and connectors must be suitably insulated and protected from moisture and sunlight because they are not weather resistant.
Product description
Model 1
- Rotate the camera by loosening the screw (using screw driver).
- Adjust the elbow joint by loosening the screw.
- The neck of the stand attached to the mounting base, rotate the stand by loosening the radial joint locking ring.
Once in position , tighten the ring again.
Model 2
- Rotate the camera by loosening the screw (using screw driver).
- Adjust the elbow joint by loosening the screw.
- The neck of the stand attached to the mounting base, rotate the stand by loosening the radial joint locking ring.
Once in position , tighten the ring again.
Model 4
- loosen the screw on each side to adjust this joint ,this enables the camera left or right.
- loosen the screw and adjust to the position you want (up or down) .
- loosen the screw on each side , to rotate the camera left or right.
Positioning the Cables
Please note, model shown is for illustration purposes only.
-
For 2 & 4 camera packs:
Connect the extension cable’s DC socket to the multiple sockets on the power splitter. Then, plug the single end of the power splitter to the DC plug on the power adapter. -
For a single camera:
Connect the extension cable’s DC socket to the DC plug on the power adapter.
Troubleshooting
Q: Video Loss appears where the image from my camera should be displaying
on my DVR?
A: 1.Check the extension cable (power and video) is securely connected to the
camera.
2.Check the video output from the camera is securely connected to a video
input channel on the DVR.
3.Check the power from the camera is securely connected to a power supply.
Q: When I view an image from the camera at night I only see a bright spot
and no image?
A: A reflection can be caused in night vision mode if the camera is looking
through a window. At night, the infrared light the
camera uses to see in the dark can ‘bounce back’ off a reflective surface
(such as glass, water, spider webs, some ceramics
and so on) and effectively blind the camera. If you want to see outside, mount
the camera outside – we made it weatherproof for
a reason!
Q: The BNC extension cable will not connect to my TV?
A: Many TV’s and monitors do not have a BNC connector but do have an RCA
connector. Connect a BNC to RCA adapter to the
end of the extension cable and then plug into the RCA video input on your TV
or monitor.
CUSTOMER SUPPORT
All rights reserved. No part of this publication may be reproduced by any
means without written permission from ZOSI. The information in this
publication is believed to be accurate in all respects.
ZOSI cannot assume responsibility for any consequences resulting from the use
thereof. The information contained herein is subject to change without notice.
Revisions or new editions to this publication may be issued to incorporate
such changes.
www.zositech.com
service@zositech.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>