AUDIO ARRAY AI-02 2×2 USB-C Audio Interface User Manual

Y AI-02 2×2 USB-C Audio Interface

Thank you!

Thank you for purchasing Interface. We recommend that you spend some time reading this instruction manual in order that your fully understand all the operational

QUICK SETUP GUIDE

GETTING STARTED

1. Windows or Mac OS X operating system: operating system: No drivers needed

2. Connect to a computer via the provided USB-C cable.
   Design your interface device as your audio in Yourdon software.

3. Connect a pair of studio headphones to the connector to monitor input levels and playback from your audio software. Use the PHONES knob to adjust the headphone volume. En9 age the DIRECT MONITOR button to achieve zero latency monitoring of your input signals.

4. Connect instruments and audio sources to INPUT 1 and INPUT 2. Use GAIN I and GAIN 2 knobs to adjust the input revel of the connected audio sources. Engage the +48 V phantom power switch on the rear panel if you are recording with condemner microphones.

5. Connect a pair or studio monitor’s to the L & R MAIN OUTS ro .. playback and mixing. Use the MONITOR knob to adjust the volume level at the MAIN OUT.

CONTROLS

[1] INPUT 1 & 2 GAIN 1 & 2 knob adjusts the input level at INPUT 1 & 2
SIG LED indicates that an audio signal is present in the channel.

[2] Monitor knob adjusts the output level at the L & R MAINOUT [3] PHONES knob adjusts the output level at the
[headphones) output
[4&6] LINE / INST selector designates line level or instrument level input source at combination XLR / ¼” connector[s]

[5] INPUT 1 & 2 combination XLR / ¼” connectors.
Connect microphones, instruments or line level audio sources to these connectors
[7] LOOPBACK selector designates input playback signal

[8] DIRECT MONITOR selector activates direct monitoring of input signals with zero latency leno delay) when engaged [9] Headphone output: Connect headphones for playback and mixing [10] USB type C connector: Connect to a computer via this connector [11] +48 VON/OFF selector engages +48 V phantom power !required for professional studio condenser microphones] [12] L & R MAIN OUT connect to powered studio monitors for playback and mixing.

SPECIFICATIONS

Preamp 2 x MIDAS design Input Type 2 x XLR/TRS combo connector
Frequency response 10 Hz – 50 kHz ID/ -3 dB] Impedance Mic in:3 k O / Inst in: 1 MO
Max. input level Mic:-4 dBu / Line:+20 dBu / last:-3 dBu
Phantom power +48 V, switchable
Output type 1 x ¼” stereo [Phonesl.2 x ¼” TRS [Line Out)
Max. output level +3 dBu
Dynamic range 110 dB, A-weighted
Direct monitor control Direct Monitor switch
Supported sample rates 44.1 / 48 I 96 / 192 kHz
Bit Per Second 16bit/24bit
Computer Bus Connectivity type USB 3.0, type C
Operating systems Mac OS X, Windows XP or higher*
Power consumption Max. 2.5 W Power supply USB connector
Dimensions [H x W x DI 45 x 175x 110 mm

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>