NOVY 56014 Gas hob Gas Pro Drum Instruction Manual

NOVY 56014 Gas hob Gas Pro Drum

Worktop: Materials and dimensions

Worktop materials
The unit can safely be built into:

• Compact board (eg. Trespass)
• Quartz Composite (eg. Caesar stone, Siltstone)
• Concrete
• Glass
• Natural stone (eg. granite, marble)
• Stainless steel
• Ceramics

The unit should never be installed into solid wood, Solid Surface materials and worktops with an HPL top layer.

Thickness

• The minimum thickness of the core material is 4 mm.
• For Quartz composite, compact board and natural stone applies a minimum thickness of the core material (solid) of 10 mm.
• Maximum thickness of 35 mm.

Depth worktop

• A minimum worktop depth of 600 mm applies to all basic models.

The bottom of the core material needs to be completely flat, in order to bring the heat conductor in full contact with the worktop.

Manufacturing recesses (cut-outs)

The guidelines of the kitchen manufacturer and/or the manufacturer of the kitchen worktop should always be strictly followed. The C-size should be at least 50 mm (fig.1).

The distance between the cut out and the sides (left or right) of the worktop should be at least 150 mm.

1. The insides of the recess(es) should be smooth and even (fig. 5). Irregularities can cause cracking (fig. 6).
2. On the top and bottom of the recess(es) should be a facet of at least 1×1 mm be applied (fig. 7).
3. Adhesive connections and/or interconnections should never intersect the recess(es). These should have a distance of at least 250 mm to the recess(es) (fig. 8 and 9)

Installation worktop

The guidelines of the kitchen manufacturer and/or the manufacturer of the kitchen worktop should always be strictly followed.

1. The cabinets should be placed perfectly levelled (fig. 14 and 15).
2. In the case of bottom cabinets with a closed top, these should be the same size (+10 mm) as the module. This is to bring the heat conductor in full contact with the core material.
3. The worktop should have full support on the left, right, front and back side of the module (fig. 16). This prevents tension in the worktop from the weight of the cooking unit. We advise to support the worktop with a ladder frame.
4. The distance between the kitchen worktop and the wall and/or cabinets should be at least 3 mm (fig. 17). This allows the material to expand.

Installation

Strictly follow the installation instructions.

1. The module should always be fully supported with the support bar set to prevent bending of the kitchen worktop (fig. 18 and 19).
2. In case of service, the module should ALWAYS be able to be disassembled without disassembling the cabinets and/or kitchen worktop (fig. 20).

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>