NOVY 800996 Mini Pureline Motor Instruction Manual

: June 3, 2024
: NOVY

Table of Contents

NOVY 800996 Mini Pureline Motor
INSTRUCTIONS FOR SAFETY AND USE
INSTALLATION
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

NOVY 800996 Mini Pureline Motor

NOVY-800996-Mini-Pureline-Motor-PRODUCT-IMAGE

INSTRUCTIONS FOR SAFETY AND USE

Further information on Novy products, accessories and services may be found on the internet: www.novy.co.uk These are the installation instructions for the appliance shown on the front.
These directions for use make use of a number of symbols. The meanings of the symbols are shown below.

Symbol	Meaning	Action
Indication	Explanation of an indication on the device.
Warning	This symbol indicates an important tip or a dangerous situation

Warnings before installation

Read the directions for use and the installation instructions before installing and using this appliance. You will find important information here for the assembly and use of the appliance.
Check on the basis of the drawing A that all the materials for installation have been supplied.
The appliance is intended exclusively for household use (preparation of food) and excludes all other domestic, commercial or industrial use. Do not use the appliance outside.
Keep good care of this manual and pass it on to any person who may use the appliance after you.
This appliance complies with the applicable safety instructions. However, inexpert installation may cause personal injury or damage to the appliance.
Check the condition of the appliance and the installation fittings as soon as you remove them from the packaging. Remove the appliance from the packaging with care. Do not use sharp knives to open the packaging.
Do not install the appliance if it is damaged, and in that case inform Novy.
Novy is not liable for damage resulting from incorrect assembly, incorrect connection, incorrect use or incorrect operation.
Do not convert or alter the appliance.
Metal parts may have sharp edges, and you may injure yourself on them. For that reason, wear protective gloves during installation.

This kit enables you to disassemble the motor unit for remote installation indoors.

Carefully read the safety and installation instructions of this kit and of the built-in unit before installing and using it.
Make sure that the wall against which the motor unit is installed has sufﬁcient load bearing capacity.
The motor unit must be installed indoors.
The installation and electrical connection of the appliance may only be carried out by an authorized specialist.

INSTALLATION

Caution, do not perform any of the following operations while the unit is energized. Make sure that the power is off or that the plug of the cooker hood is unplugged.

The following adjustments to the electrical connection of the unit may only be carried out by an authorized specialist.

Make sure that the cooker hood is disconnected from the power supply.
The motor cable is located between the built-in unit and the motor unit.
Cut this cable at the level of the sticker. Remove 37 mm of cable insulation from both ends of the cut motor cable.
From the loose wire ends cut off the red wire and 2 white filler wires (= WITHOUT CORE) up to the cable insulation.
Strip the wire insulation of the remaining wires 8 mm with a stripping tool.
Apply the wire end ferrules (8 x7903180 and 2×6830181) to all wires and fix with a plier. Please note that the larger end ferrule (6830181) is reserved for the yellow/green wire.
Connect the supplied connectors (6830044 and 6830045) to the wires.
Fit the Female connector (6830044) to the cable coming from the the built-in unit.
Fit the Male connector (6830045) to the cable leading to the motor unit.
Position the wires and screw them on as shown in drawing 7.
This is necessary for the proper operation and to avoid damaging the cooker hood.
Close the covers of the connectors and screw them on. This is also the strain relief for the cables.
Everything is now ready to connect the extension cable 990396 to the connectors of the built in unit and the motor unit (see step 16).
Uninstall the motor unit of the built-in unit.
- Open the bottom plate and remove the grease ﬁlter. If a recirculation ﬁlter is present, remove it also.
- Loosen the screws located next to the protective grid. The motor unit is now disconnected from the cooker hood.
Screw the ﬂange plate 820828 onto the motor unit with 4 of the supplied screws 906116.
Stick the supplied insulating strip 801006 on the underside of the other ﬂange plate 820828. Then screw this ﬂange plate to the built in unit using 4 of the screws supplied 906116.
Determine the place where you want to place/hang the motor unit. If necessary, the exhaust direction of the motor unit can be changed by removing 8 screws from the motor cover and turning the motor cover a quarter turn. Before fastening the 2 brackets 830822, remove the screws of the motor cover on the side on which you want the suspension brackets to be placed. Attach the suspensions brackets onto the motor unit using the original screws.
Mount the built-in unit in the recess as described in the installation instructions of the concerned built-in unit.
Install the motor unit onto the wall. Attention! Do not attach the motor to the ceiling. For this use the supplied screws and any plugs, if necessary. The supply and exhaust pipes can be made in a 90° angle or in a straight line.
Use for all hood models a duct of Ø150 mm between the built-in unit and the motor unit. Attach the exhaust duct to the ﬂange plate on the build-in unit and on the motor unit using a hose clamp or aluminium tape.
Connect the supplied cable (990396) between the build-in unit and the motor unit using the connectors. The length of this cable is 5 m. Optional, you can order an extra extension cable (7000094) , resulting in a total cable length of 10 m.
Mount the strain reliefs 6830046 on the two connector connections.
Place the grease filter and, if applicable, the recirculation ﬁlter in the cooker hood.
Check that the ﬁlters are ﬁtted and locked properly. Close the bottom panel.
The power can now be restored and the cooker hood is ready for use.

NOVY nv reserves the right at any time and without reservation to change the structure and the prices of its products.

NOVY nv Noordlaan 6
B – 8520 KUURNE Tel. 056/36.51.00 Fax 056/35.32.51
E-mail: novy@novy.be www.novy.be
www.novy.com

France: Tél: 0320.940662
Deutschland und Österreich: Tel: +49 (0)511.54.20.771
Nederland: Tel.: +31 (0)88-0119110
United Kingdom: +44 (0)207 866 2493
España: Tel.: +34 938 700 895
Italia: Tel.: +39 039.20.57.501