JVM6175SK Range Sensor Microwave Oven Installation Guide
- June 14, 2024
- GE
Table of Contents
JVM6175SK/EK/BL/YK
GE® 1.7 cu. ft. Over-the-Range Sensor Microwave Oven
DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)
NOTE: Requires 120V grounded outlet. Electrical receptacle must be
located in cabinet above microwave oven. No additional wiring, venting or
cabinet rebuilding necessary in Many cases. Complete detailed, easy-to-follow
installation instructions and convenient full-size templates are packed with
the microwave oven.
IMPORTANT INFORMATION : When installing the microwave oven over a range,
allow minimum of 2″ from bottom of microwave oven to top of range back guard
to allow for removal of light covers.
VENTILATION OPTIONS: The microwave ovens are designed for adaptation to
the following three types of ventilation:
-Outside exhaust (vertical – as shown)
-Outside exhaust (horizontal)
-Recirculating (non-vented ductless – see Filter Kit drawing)
INSTALLATION INFORMATION: This information is not intended to be used for
installing unit described. Before installing, consult installation
instructions packed with product/kit for current dimensional data.
HOOD EXHAUST DUCT: Outside ventilation requires a HOOD EXHAUST DUCT. Read
the following carefully.
EXHAUST CONNECTION : The hood exhaust has been designed to mate with a
standard 3-1/4″ x 10″ rectangular duct. If a round duct is required, a
rectangular-to-round transition adaptor must be used. Do not use less than a
6″ diameter duct
REAR EXHAUST: If a rear or horizontal exhaust is to be used, care should
be taken to align exhaust with space between studs, or wall should be prepared
at the time it is constructed by leaving enough space between the wall studs
to accommodate exhaust.
MAXIMUM DUCT LENGTH : For satisfactory air movement, the total duct
length of 3-1/4″ x 10″ rectangular or 6″ diameter round duct should not exceed
140 equivalent feet.
ELBOWS, TRANSITIONS, WALL AND ROOF CAPS, etc., present additional
resistance to airflow and are equivalent to a section of straight duct which is
longer than their actual physical size. When calculating the total duct
length, add the equivalent length of all transitions and adaptors plus the
lengths of all straight duct sections. The chart below shows the approximate
feet of equivalent length of some typical ducts.
| DUCT | EQUIVALENT FEET |
|---|---|
| A. Rectangular-to-round Transition Adaptor | 5 ft. |
| B. Wall Cap | 40 ft. |
| C. 90° Elbow | 10 ft. |
| D. 45° Elbow | 5 ft. |
| E. 90° Elbow | 25 ft. |
| F. 45° Elbow | 5 ft. |
| G. Roof Cap | 24 ft. |
OPTIONAL ACCESSORIES
FEATURES AND BENEFITS
1.7 cu. ft. capacity – 1000 microwave watts (IEC test procedure)
Weight and time defrost – Simply enter the weight of the food, and the oven
automatically sets the optimal defrosting time and power level or set your
desired time for defrosting
“Add 30 seconds” button – Add 30 seconds of microwave cooking time Two-speed,
300 CFM venting system – Removes smoke, steam and odors
Upfront charcoal filter with indicator light – Light indicates when odor-
removing charcoal filter needs to be replaced
Turntable with on/off – Controls turntable operation
Sensor cooking controls – Automatically adjust time and power for delicious
cooking results
Model JVM6175SKSS – Stainless steel
Model JVM6175EKES – Slate
Model JVM6175BLTS – Black Stainless
Model JVM6175YKFS – Fingerprint Resistant Stainless Steel
For answers to your Monogram, Café™, GE Profile™ or
GE Appliances product questions, visit our website at
geappliances.com
or call GE Answer Center® Service, 800.626.2000.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>