Pipishell PIMF11 Full Motion TV Wall Mount Instruction Manual
- June 14, 2024
- Pipishell
Table of Contents
Pipishell PIMF11 Full Motion TV Wall Mount Instruction Manual
CAUTION IMPORTANT SAFETY INFORMATION
DANGER Please carefully read all instructions before attempting installation. If you do not understand the instructions or if you have any concerns or questions, please contact our technical support line support line at 1-800-556-9829 (US / CA) / 44-808-196-3885 (UK) or customer service at support@pipishell.net.
- Before starting assembly, confirm that all parts are included and undamaged. Do not use damaged or defective parts. If you require replacement parts, contact our technical support line at 1-800-556-9829 (US / CA) / 44-808-196-3885 (UK) or customer service at support@pipishell.net.
- Not all hardware included in this package will be used.
- Do not use outdoors.
- Route cords and cables properly to avoid mechanical damage.
Caution
Avoid the risk of personal injury or property damage!
« Do not use this product for any purpose that is NOT explicitly specified in
this manual. Do not exceed the maximum weight capacity. We are not liable for
damage or injury caused by incorrect assembly, improper mounting, or
inappropriate use.
Warning
concrete, concrete block. DO NOT install on drywall alone.
-
The wall must be capable of supporting four times the weight of the TV and mount combined.
-
DO NOT exceed the maximum weight indicated. This mounting system is intended for use only within the maximum weights indicated. Exceeding weights indicated may result in failure of the mount and its accessories, causing possible damage and/or injury.
-
Avoid the risk of personal injury or property damage! Tighten the lag screws only until they are pulled firmly against the wall plate (DO NOT overtighten).
Do not use a drill; only use a socket wrench. -
Do not use wall anchors for this mounting option. Wall anchors are used for solid concrete, concrete block installations only. * Minimum wood stud size: 1 1/2″ (W) x 3 1/2″ (D) (38 x 89mm).
Note for Solid Concrete, Concrete Block Installation (Page 13)
-
Avoid the risk of personal injury or property damage! Tighten the lag screws only until they are pulled firmly against the wall plate (DO NOT overtighten).
Do not use a drill; only use a socket wrench. -
Mount the arm assembly / wall plate directly on the concrete surface.
-
Minimum solid concrete thickness: 8″ (203mm). * Minimum concrete block size: 8” x 8″ x 16″ (203 x 203 x 406mm).
-
Never drill into the mortar between blocks.
Read More About This Manual & Download PDF
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>