PowerA Joy Con Charging Dock for Nintendo Switch Instruction Manual

: June 14, 2024
: PowerA

Table of Contents

Joy Con Charging Dock for Nintendo Switch
CONTENTS
SETUP
USE
TROUBLESHOOTING
FCC STATEMENT
WARRANTY
AUSTRALIAN WARRANTY STATEMENT
AU WHOLESALE DISTRIBUTOR
ADDITIONAL LEGAL
REGIONAL COMPLIANCE SYMBOLS
TWO YEAR LIMITED WARRANTY
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

JOY-CON™
CHARGING DOCK for Nintendo Switch™
USER MANUAL

Joy Con Charging Dock for Nintendo Switch

Connect Joy-Con Charging Dock to the Nintendo Switch dock

Slide the Joy-Con controllers down to charge

LED indicator lights will illuminate when Joy-Con controllers are properly seated

SETUP

Plug the USB power cable into any available USB port on the Nintendo Switch dock.
Excess power cable length can be wrapped inside of the base of the Joy-Con Charging Dock.

USE

To charge Joy-Con controllers, slide them down onto the dock.
Remove the Joy-Con controllers from the Charging Dock one at a time, by placing one or two fingers on top of the dock, firmly gripping the Joy-Con controller, and pulling directly upward.
An LED will illuminate when the controller is fully docked.
A RED LED indicates charging. A GREEN LED indicates a full charge.

TROUBLESHOOTING

Q: Joy-Con Charging Dock is not charging
A: Ensure that the Joy-Con controllers are pressed down and completely docked. If no LEDs illuminate, check that the Nintendo Switch dock is turned on, and that the Joy-Con Charging Dock is connected to the Nintendo Switch dock via the USB power cable.

FCC STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

this device may not cause harmful interference, and
this device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to Part 15 of the FCC Rules.
CAN ICES-003(B)/NMB-003(B)
This device complies with Industry Canada Incense exempt RSS standard(s). Operation is subject to the following two conditions:

This device may not cause interference, and
this device must accept any interference, including interference that may cause undesired operation of the device.

MANUFACTURED BY
ACCO Brands USA LLC, 4 Corporate Way,
Lake Zurich, IL 60047
ACCOBRANDS.com
POWERA.com
Made In China
CONTACT/SUPPORT
For support with your authentic Power accessories, please visit PowerA.com/Support.

WARRANTY

2-Year Limited Warranty
Visit PowerA.com/support for details.

AUSTRALIAN WARRANTY STATEMENT

This product comes with guarantees that cannot be excluded under the Australian Consumer Law.
You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage.
You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. If purchased within Australia or New Zealand, this product comes with a one-year warranty from date of purchase. Defects in the product must have appeared within one year from date of purchase, in order to claim the warranty.
All warranty claims must be facilitated back through the retailer of purchase in accordance with the retailer’s return policies and procedures.
Any expenses incurred, as a result of returning the product to the retailer of purchase are the full responsibility of the consumer.

AU WHOLESALE DISTRIBUTOR

Level 2, 2 Darling Street South Yara,
Australia VIC 3141
bluemouth.com.au
Email:support@bluemouth.com.au
+61 (3) 9867 2666

ADDITIONAL LEGAL

© 2021 ACCO Brands USA LLC. Power and Power Logo are trademarks of ACCO Brands Corporation. Nintendo Switch is a trademark of Nintendo. Licensed by Nintendo. All rights reserved. All other trademarks are the property of their respective owners.

REGIONAL COMPLIANCE SYMBOLS

More information available via web-search of each symbol name.
** The WEEE (Waste of electrical and electronic equipment) symbol requires battery disposal outside of other household waste per local regulations. Contact your city office, waste disposal service, or retailer for guidance.
The CE (Conformité European aka European Conformity) mark is a declaration from the manufacturer that the product meets applicable European
Directives and Regulations for health, safety, and environmental protection.
The UKCA (UK Conformity Assessment) mark is a declaration from the manufacturer that the product meets applicable UK Regulations for health, safety, and environmental protection.
The Regulatory Compliance Mark is a visible indication of a product’s compliance with all applicable ACMA (Australian Communications and Media Authority) regulatory arrangements, including all technical and record keeping requirements regarding the electrical safety and/or electromagnetic compatibility (EMC).
DECLARATION OF CONFORMITY
Hereby, ACCO Brands USA LLC at 4 Corporate Way, Lake Zurich, IL 60047 USA, declares that this wired charger is in compliance with Directive 2014/30/EU. The full text of the EU Declaration of Conformity is available at the following internet address: PowerA.com/compliance
Customer Service**
PowerA.com/Support