Nintendo Switch Fusion Pro Wireless Controller User Manual – PowerA
- June 2, 2024
- PowerA
Table of Contents
User Manual
Nintendo Switch Fusion Pro Wireless Controller User Manual
FRONT
BACK
THUMBSTICK / FACEPLATE REPLACEMENT
MAPPING PRO PACK PADDLES
NOTE: Repeat for the remaining Pro Pack paddles. Pro Pack paddle assignments will remain in memory even after disconnected.
RESETTING THE PRO PACK PADDLES
PRO PACK INSTALLATION/REMOVAL
NOTE: Store all unused components in protective case when not in use.
RECHARGEABLE 900 MAH INTERNAL BATTERY
Controller was charged at the factory, but if top LED is flashing red, plug in
USB cable to
charge prior to initial pairing. Get up to 30 hours of game play when fully
charged (other
variables affect play time).
NOTE: Remember to charge controller at least once every 45-60 days
(regardless of use)
so battery retains ability to charge. Battery capacity will gradually reduce
over time with
repeated charging.
WIRELESS PAIRING
From the HOME Menu, select ‘Controllers,’ then ‘Change Grip and Order.’ While
the
following screen is displayed, press and hold down the SYNC Button for at
least one
second on the controller you wish to pair.
NOTE: After controller is paired once, it will autoconnect next time.
UNDERSTANDING LED INDICATORS
-
The top LED near the USB port will flash red when the internal battery is near
depletion. Plug in USB cable to charge once indicator is flashing for uninterrupted
game play. LED will turn solid red during charging, and off once fully charged. -
The front LED (between Capture and Home buttons) will flash during programming of
Advanced Gaming Buttons. -
The four LEDs on the bottom indicate Power & player number 1-8, and will cycle from
left to right during wireless pairing.
TROUBLESHOOTING
For latest FAQs, visit Power A.com/Support
PROBLEM: My FUSION Pro Wireless Controller is not pairing.
SOLUTION: Confirm batteries are charged by plugging in USB-C cable.
SOLUTION: Confirm you are following the ‘Wireless Pairing’ process.
SOLUTION: Insert paper clip into Factory Reset Hole as marked above to reset
controller
to factory settings.
BATTERY WARNING – CAUTION
-
Don’t attempt to replace the rechargeable battery yourself. There is a serious risk of
explosion if the battery is incorrectly replaced. -
The lithium-ion battery in your device should be serviced or recycled by PowerA, or an
authorized provider and must be recycled or disposed of separately from household
waste. Dispose of batteries according to your local environment laws and guidelines. -
Disposal of a battery or a controller that contains batteries into a fire, or
mechanically crushing or cutting of a battery, can result in an explosion. -
Leaving a battery or a controller that contains batteries in extremely high-temperature
environment can result in an explosion or leakage of flammable liquid or gas. -
A battery or controller that contains batteries that is subjected to extremely low air
pressure may result in an explosion or leakage of flammable liquid or gas. -
Don’t use the rechargeable battery in a location where there is a lot of static electricity,
as the internal safety functions may be damaged, causing a dangerous situation. -
In case any electrolytes get into the eyes due to battery leakage, do not rub your
eyes! Instead, immediately rinse your eyes with clean running water and seek
medical attention right away. -
If the battery gives off an odor, generates heat, or in any way appears abnormal
during use, recharging or storage, immediately remove the controller from the
battery charger and place it in a secure container such as a metal box.
MOTION WARNING
Playing video games can make your muscles, joints, skin or eyes hurt. Follow
these
instructions to avoid problems such as tendinitis, carpal tunnel syndrome,
skin irritation
or eyestrain:
-
Avoid excessive play. Take a 10 to 15 minute break every hour, even if you don’t think
you need it. Parents should monitor their children for appropriate play. -
If your hands, wrists, arms or eyes become tired or sore while playing, or if you feel
symptoms such as tingling, numbness, burning or stiffness, stop and rest for several
hours before playing again. -
If you continue to have any of the above symptoms or other discomfort during or
after play, stop playing and see a doctor.
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following
two conditions: (1) this device may not cause harmful interference, and (2)
this device
must accept any interference received, including interference that may cause
undesired
operation.
WARNING: Changes or modifications to this unit not expressly approved by
the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits
for Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide
reasonable protection against harmful interference in a residential
installation. This
equipment generates, uses and can radiate radio frequency energy and, if not
installed
and used in accordance with the instructions, may cause harmful interference
to radio
communications. However, there is no guarantee that interference will not
occur in a
particular installation. If this equipment does cause harmful interference to
radio or
television reception, which can be determined by turning the equipment off and
on, the user
is encouraged to try to correct the interference by one or more of the
following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected. -
Consult the dealer or an experienced radio/TV technician for help.
CAN ICES-3(B)/NMB-3(B)
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with
Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:
- This device may not cause interference;
- This device must accept any interference, including interference that may cause
undesired operation of the device
CONTACT/SUPPORT
For support with your authentic Power A accessories, please visit
PowerA.com/Support.
MANUFACTURED BY
Bensussen Deutsch & Associates, LLC. (BDA, LLC.) 15525 Woodinville-Redmond Rd.
NE
Woodinville, WA 98072. | BDAINC.com | POWERA.com
WARRANTY
2-Year Limited Warranty: Visit PowerA.com/support for details.
AUSTRALIAN WARRANTY STATEMENT
This product comes with guarantees that cannot be excluded under the
Australian
Consumer Law. You are entitled to a replacement or refund for a major failure
and for
compensation for any other reasonably foreseeable loss or damage. You are also
entitled
to have the goods repaired or replaced if the goods fail to be of acceptable
quality and the
failure does not amount to a major failure. If purchased within Australia or
New Zealand,
this product comes with a One-year warranty from date of purchase. Defects in
the product
must have appeared within One year from date of purchase, in order to claim
the warranty.
All warranty claims must be facilitated back through the retailer of purchase
in accordance
with the retailer’s return policies and procedures. Any expenses incurred, as
a result of
returning the product to the retailer of purchase are the full responsibility
of the consumer.
AU WHOLESALE DISTRIBUTOR
Level 2, 2 Darling Street South Yarra, Australia VIC 3141
bluemouth.com.au Email: support@bluemouth.com.au +61 (3) 9867 2666
ADDITIONAL LEGAL
© 2021 Bensussen Deutsch & Associates, LLC. Power A, the Power A logo, and the
Fusion
logo are trademarks of Bensussen Deutsch & Associates, LLC, Woodinville, WA
98072.
Manufactured and distributed under license by Nintendo. Nintendo Switch is a
trademark
of Nintendo. Licensed by Nintendo. Made in China.
REGIONAL COMPLIANCE SYMBOLS
More information available via web-search of each symbol name.
The WEEE (Waste of electrical and electronic equipment) symbol requires
battery disposal outside of other household waste per local regulations.
Contact your city office, waste disposal service, or retailer for guidance.
CE (Conformité Européene aka European Conformity) is a certification mark
that indicates conformity with health, safety, and environmental protection
standards for products sold within the European Economic Area.
The Regulatory Compliance Mark is a visible indication of a product’s
compliance with all applicable ACMA (Australian Communications and Media
Authority) regulatory arrangements, including all technical and recordkeeping
requirements regarding the electrical safety and/or electromagnetic
compatibility (EMC).
DECLARATION OF CONFORMITY
Hereby, Bensussen Deutsch & Associates LLC at 15525 Woodinville-Redmond Road
NE,
Woodinville, WA 98072 USA, declares that this wireless controller is in
compliance with
Directive 2014/53/EU. The full text of the EU Declaration of Conformity is
available at the
following internet address: PowerA.com/compliance
WIRELESS RATING FOR EU COMPLIANCE
FREQUENCY RANGE: 2.4 – 2.4835GHz
MAX E.I.R.P.: < 10dBm for EU
OPERATION TEMPERATURE: 10 – 45°C
2-YEAR LIMITED WARRANTY
VISIT POWERA.COM/SUPPORT FOR DETAILS 
CONTENTS
FUSION Pro Wireless Controller | Custom protective case
Pro Pack with removable paddles | Pro Pack cover | Alternate faceplate
Two extra analog sticks | 9.8ft (3m) braided USB-C cable | User guide
*NOTE: The included USB cable is a dedicated (proprietary) USB cable for
this FUSION Pro Wireless Controller
Read More About This Manual & Download PDF:
Nintendo Switch Fusion Pro Wireless Controller User Manual – PowerA –
Optimized PDF
Nintendo Switch Fusion Pro Wireless Controller User Manual – PowerA –
Original PDF
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>