PowerA 1516956-01 (NA) Twin Charging Station for DualSense Wireless Controllers User Manual

: June 3, 2024
: PowerA

Table of Contents

PowerA 1516956-01 (NA) Twin Charging Station for DualSense Wireless
CONTENTS
SETUP
TROUBLESHOOTING
TWIN CHARGING STATION
AC ADAPTER
FCC STATEMENT (US ONLY)
DECLARATION OF CONFORMITY
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

PowerA 1516956-01 (NA) Twin Charging Station for DualSense Wireless

Controllers

$PowerA 1516956-01 $NA$ Twin Charging Station for DualSense Wireless Controllers-FIG1$

Connect the AC Adapter to the unit and plug into an electrical outlet
Line up the terminals and place the controller onto the charger
When the light bar stops blinking, charging is complete
Lift the controller off the charger when ready to play

$PowerA 1516956-01 $NA$ Twin Charging Station for DualSense Wireless Controllers-FIG2$

SETUP

Connect the included AC adapter to the DC-in con-nector located on the bottom of the Twin Charging Station, then plug the AC adapter into an electrical outlet.
Place your DualSense Wireless Controller onto the charging cradle making sure that the charging connector is lined up with the charging terminals of the controller.
The light bar on the DualSense Wireless Controller slowly blinks orange while the controller charges and will turn off when charging is complete.
Once charged, simply lift the DualSense Wireless Controller off the Twin Charging Station when you are ready to play.

TROUBLESHOOTING

Q: Why are my wireless controllers not charging?
- A: Confirm the AC adapter is connected to both the Twin Charging Station and an electrical outlet.
- A: Confirm the DualSense Wireless Controller charging terminals are lined up with the charging connector of the Twin Charging Station.
- A: Your DualSense Wireless Controller might already be fully charged.

TWIN CHARGING STATION

INPUT VOLTAGE (X, V)| 5.3V
INPUT CURRENT (X.X, A)| 2.0A
OUTPUT VOLTAGE (X.X, V)| 5.0V DC
OUTPUT CURRENT (X.X, V)| 800mA*2

AC ADAPTER

≥79.11% (115V)

NO-LOAD POWER CONSUMPTION (X.XX, W)| ≤0.1W (230V);

≤0.1W (115V)

FCC STATEMENT (US ONLY)

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to Part 15 of the FCC Rules.

CAN ICES-003(B)/NMB-003(B) (CANADA ONLY)
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference; (2) This device must accept any interference, including interference that may cause undesired operation of the device

MANUFACTURED BY
ACCO Brands USA LLC, 4 Corporate Way, Lake Zurich, IL 60047 ACCOBRANDS.COM | POWERA.COM | MADE IN CHINA

CONTACT/SUPPORT
For support with your authentic PowerA accessories, please visit PowerA.com/Support.

WARRANTY
2-Year Limited Warranty: Visit PowerA.com/support for details.

AUSTRALIAN WARRANTY STATEMENT
This product comes with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. If purchased within Australia or New Zealand, this product comes with a one-year warranty from date of purchase. Defects in the product must have appeared within one year from date of purchase, in order to claim the warranty. All warranty claims must be facilitated back through the retailer of purchase in accordance with the retailer’s return policies and procedures. Any expenses incurred, as a result of returning the product to the retailer of purchase are the full responsibility of the consumer.

AU WHOLESALE DISTRIBUTOR
Level 2, 2 Darling Street
South Yarra, Australia VIC 3141
bluemouth.com.au | +61 (3) 9867 2666
Email: support@bluemouth.com.au

ADDITIONAL LEGAL
© 2021 ACCO Brands USA LLC. PowerA and PowerA Logo are trademarks of ACCO Brands Corporation. “1”, “PlayStation”, “PS5”, and “DualSense” are registered trademarks or trademarks of Sony Interactive Entertainment Inc. All rights reserved. All other trademarks are the property of their respective owners. Manufactured and distributed under license by Sony Interactive Entertainment LLC.

REGIONAL COMPLIANCE SYMBOLS
More information available via web-search of each symbol name.

(EU, UK and Turkey Only) The WEEE (Waste of electrical and electronic equipment) symbol requires battery disposal outside of other household waste per local regulations. Contact your city office, waste disposal service, or retailer for guidance.
(EU and Turkey Only) The CE (Conformité Européene aka European Conformity) mark is a declaration from the manufacturer that the product meets applicable European Directives and Regulations for health, safety, and environmental protection.
(UK Only) The UKCA (UK Conformity Assessment) mark is a declaration from
the manufacturer that the product meets applicable UK Regulations for health, safety, and environmental protection.
(Australia only) The Regulatory Compliance Mark is a visible indication of a product’s compliance with all applicable ACMA (Australian Communications and Media Authority) regulatory arrangements, including all technical and record-keeping requirements regarding the electrical safety and/or electromagnetic compatibility (EMC).

DECLARATION OF CONFORMITY

Hereby, ACCO Brands USA LLC at 4 Corporate Way, Lake Zurich, IL 60047 USA, declares that this wired charger is in compliance with Directive 2014/30/EU. The full text of the EU Declaration of Conformity is available at the following internet address: PowerA.com/compliance