BARSKA BC168 BioMetric Safe Instruction Manual

BARSKA BC168 Biometric Safe

Keep your valuables from the wrong hands with the Barska Biometric Safe. The safe opens at the touch of a finger but only yours. Fingerprint control can store up to 30 permanent or temporary users, allowing you to control who can access the safe. The compact design makes it easy to hide nearly anywhere. The weight of the safe is 31 pounds.

Note
When selecting a place for the safe please keep in mind

• Safe must be supported beneath a shelf and/or floor.
• The door of the safe must be able to swing open at least 85°.
• For added security, purchase 3½ wood screws at your local hardware store.
• When using alternate screws, adjust mounting instructions accordingly.
• The metallic anchors supplied may not reach the wall stud.
• These instructions are meant to keep safe in place, and will not deter theft.

SETUP

Tools Needed

• 1x-Drill
• 1 x -15/32″ Drill Bit
• 1 x -15/32″ Socket Wrench

Parts Included

• 1 x -Allen Wrench
• 2x -Emergency Keys
• 2x -Flat Washers
• 2x -Metallic Anchors

WALL MOUNTING

1. Two of the three mounting holes in the rear of the safe will be used to fasten the safe to the wall.
2. Place the safe into position, with the door of the safe open, and mark mounting holes 1 and 2 on the rear wall from inside the safe. Set safe aside.
3. According to the marks drill two 15/32″ holes.
4. Disassemble one metallic anchor. Fit the nut into the graved end of the shaft. See diagram A below. Insert this assembled piece into the wall hole. Repeat this step with the other metallic anchor and into the other hole.
5. Set the safe into place, aligning the holes of the safe to the holes of the wall.
6. Open the safe and from the inside of the safe insert washer into the screw. Slide this piece into the shaft. See diagram B below.
7. Tighten the metallic anchors using the 15/32″ socket wrench.
8. Close safe.

Metallic Anchor

Diagram of wall-mounted Safe

FLOOR MOUNTING

Under Side of Safe

1. One of the mounting holes in the bottom of the safe will be used to fasten the safe to the floor.

2. Pull back any carpet off the floor. Place the safe into position, remove the liner from the safe and with the door of the safe open, mark the hole on the bottom of the safe from the inside.
   Note: The safe can be mounted to the floor directly on top of the existing carpet, but may not be as secure. Set safe aside

3. According to the mark, drill a 15/32″ hole into the floor.

4. Disassemble the metallic anchor. Fit the nut into the graved end of the shaft. See Diagram A. Insert this assembled piece into the hole in the floor.

5. Set the safe into position aligning the hole of the safe to the hole of the floor. Open safe. From the inside of the safe insert washer into the screw.

6. Slide this piece into the shaft. Diagram B.

7. Tighten the metallic anchor using the 15/32″ socket wrench.

8. Replace the liner and close the safe.

Diagram of Floor Mounted Safe

2010 BARSKA” La Verne, CA91750 www.barska.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>