ScreenBeam Mini2 Kit Instructions
- June 3, 2024
- ScreenBeam
Table of Contents
ScreenBeam Mini2 Kit
ScreenBeam Mini2 Kit Firmware Update Instruction
- Download the ScreenBeam Mini 2 Kit firmware (sbmini2_FW_x.x.xx.x.zip)
- Extract the zip file. You should see the “autorun” folder, the “install” file and this upgrade instructions guide.
- Insert your USB flash drive to an available USB port on your Laptop/PC.
- Copy both the “autorun” folder and “install” file to the top directory of the USB flash drive Note: Do not use a portable hard drive. You should use a formatted FAT/FAT32 USB flash drive only.
- Make sure the HDTV connected to the Receiver is powered on and the correct HDMI input is selected.
- Note : You must disconnect all wireless devices (Ultrabooks, smartphones and tablets) from the Receiver before upgrading the firmware.
- When the “Ready to Connect” screen appears, plug the USB flash drive into the female port of the included USB cable.
- Wait a few seconds and the firmware upgrade will start automatically. You should see the firmware upgrade message appears on your TV.
- Note : The HDTV screen may go temporarily blank for a few seconds during the upgrade process.
- Warning! Do not power off the Receiver or remove the USB flash drive while the upgrade is in progress. This may cause the firmware upgrade to fail.
- When the upgrade completes, the “Ready to Connect” screen reappears on the HDTV, with the new firmware version information displayed at the bottom left corner.
- The ScreenBeam receiver is now upgraded. Now you can remove the USB flash drive.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>