OCDAY 12V RF Wireless Remote Switch Controller Dimmer for Mini LED Strip Light Instructions

RF Wireless Remote
LED Controller

Instructions

• Dimmer & Dynamic
• 8 Dynamic Effects
• 10-Level Dimmer
• 256-Grade PWM
• Speed Adjustable
• Card Type Remote
• Ultra Slim Design
• Smooth Dimmer Effect
• 1 to 1 Remote Paired
• Auto Save Function

1. Turn On/ Standby
   Press this key to turn on the unit or switch to standby mode. The unit will turn on and restore to the previous status at powering on the moment.

2. Lighting mode
   Switch to lighting mode from dynamic mode.
   3/8/9. Dimmer Adjust
   Shortcuts Switch to 100%, 50%, or 25% brightness lighting mode.
   4/6. Dynamic Mode Adjust
   Switch to dynamic mode from lighting mode, or switch between different dynamic modes.
   5/7. Speed Adjust
   Adjust the playing speed of dynamic modes. Press SPEED+ to increase speed and press SPEED- to decrease.
   10/11. Brightness Adjust (Dimmer)
   Adjust lighting mode brightness. Press BRIGHT+ to increase brightness and press BRIGHT- to decrease.

Functions

Installing

1. Power Supply
   This unit accepts DC12Vto 24V power supply. The red cable should be connected to a positive and the black cable to a negative. Please select the proper power supply according to the LED application.

2. LED Output
   The red cable should be connected to the LED positive and the black cable to the negative. The peak output current is 6 A, please reduce the load if the main unit is overheating.
   CAUTION! Do not short circuit the LED output, this may lead to permanent damage!
   

3. Remote Control!
   Please pull out the insulating part before using it. The RF wireless remote signal can pass through a barrier, so it’s not necessary to aim at the main unit when operating. For proper receiving of the remote signal, do not install the main unit in closed metal parts. The remote battery is a 3V CR2025 type, please only replace it with the same type battery.

Specification

§ 15.19 Labelling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
§ 15.21 Information to user.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
§ 15.105 Information to the user.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
  The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure condition without restriction.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>