VOLTCRAFT 2264184 Power Pack Instruction Manual
- June 14, 2024
- VOLTCRAFT
Table of Contents
VOLTCRAFT 2264184 Power Pack Instruction Manual
Power Pack (12 V / 1500 mA)
Item No. 2264184
Intended use
The power pack serves as voltage supply for low-voltage devices with matching DC jacks. It is intended for connection to common household mains voltage (100 – 240 V/AC, 50/60 Hz). A galvanic separated DC voltage is applied to the output. The power consumption of the consuming device many not exceed the nominal voltage of the respective power pack (depends on the type). The product has a protection against short circuit and overload.
This product fulfils European and national requirements related to
electromagnetic compatibility (EMC).
Unauthorised conversion and/or modification of the device are inadmissible
because of safety and approval reasons. Any usage other than described above
is not permitted and can damage the product and lead to associated risks such
as short-circuit, fire, electric shock, etc. Please read the operating
instructions thoroughly and keep them for further reference.
Delivery content
- Power pack
- Operating instructions
Up-to-date operating instructions
Download the latest operating instructions at www.conrad.com/downloads or scan the QR code shown. Follow the instructions on the website.
Explanation of symbols
Safety instructions
Read the operating instructions carefully and especially observe the safety information. If you do not follow the safety instructions and information on proper handling in this manual, we assume no liability for any resulting personal injury or damage to property. Such cases will invalidate the warranty/guarantee.
-
The device is not a toy. Keep it out of the reach of children and pets.
-
Do not leave packaging material lying around carelessly. This may become dangerous playing material for children.
-
Protect the appliance from extreme temperatures, direct sunlight, strong jolts, high humidity, moisture, flammable gases, steam and solvents.
-
Do not place the product under any mechanical stress.
-
If it is no longer possible to operate the product safely, take it out of operation and protect it from any accidental use. Safe operation can no longer be guaranteed if the product:
– is visibly damaged,
– is no longer working properly,
– has been stored for extended periods in poor ambient conditions or
– has been subjected to any serious transport-related stresses. -
Please handle the product carefully. Jolts, impacts or a fall even from a low height can damage the product.
-
Consult an expert when in doubt about the operation, safety or connection of the appliance.
-
Maintenance, modifications and repairs must only be completed by a technician or an authorised repair centre.
-
If you have questions which remain unanswered by these operating instructions, contact our technical support service or other technical personnel.
-
Never switch the device on immediately after having taken it from a cold to a warm environment. Under adverse conditions, the resulting condensation could destroy the device. Allow the device to reach room temperature before switching it on.
-
Power units are not designed for application to human beings or animals.
Operation
Periodically check the technical safety of the device, e.g. check for damage
to the housing etc.
Always lay the cable so that nobody can trip over or become entangled in it.
This poses a risk of injury.
- Connect the DC plug of the power pack with the DC jack on the low-voltage device.
- The polarity cannot be altered. The plug has the fixed polarity „inside plus (+), outside minus (-)“.
- Make sure that the consumer is switched off when connected to the power pack.
- Plug the power pack into a standard domestic wall socket. Correct operation is signaled at the power pack by a LED.
- To remove the consumer, proceed in reverse sequence.
Troubleshooting
By purchasing the power pack you have acquired a product that has been designed to the state of the art and is operationally reliable. Problems and malfunctions can occur nevertheless. We would therefore like to show how you can rectify certain faults yourself:
Disposal
This symbol must appear on any electrical and electronic equipment placed on the EU market. This symbol indicates that this device should not be disposed of as unsorted municipal waste at the end of its service life.
Owners of WEEE (Waste from Electrical and Electronic Equipment) shall dispose of it separately from unsorted municipal waste. Spent batteries and accumulators, which are not enclosed by the WEEE, as well as lamps that can be removed from the WEEE in a non-destructive manner, must be removed by end users from the WEEE in a non-destructive manner before it is handed over to a collection point.
Distributors of electrical and electronic equipment are legally obliged to provide free take-back of waste. Conrad provides the following return options free of charge (more details on our website):
- in our Conrad offices
- at the Conrad collection points
- at the collection points of public waste management authorities or the collection points set up by manufacturers or distributors within the meaning of the ElektroG
End users are responsible for deleting personal data from the WEEE to be disposed of.
It should be noted that different obligations about the return or recycling of WEEE may apply in countries outside of Germany.
Technical data
a) Data according to EU regulation 2019/1782
b) Other
Operating conditions…………………. 0 to +40 ºC, 20 – 85 % RH (non-condensing)
Storage conditions……………………. -20 to +60 ºC, 10 – 90 % RH (non-condensing)
Dimensions (W x H x D)…………….51 x 73 x 82 mm
Weight…………………………………….130 g
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com). All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represent the technical status at the time of printing.
Copyright 2023 by Conrad Electronic SE.
Read More About This Manual & Download PDF: