VOLTCRAFT 2176717 Power Bank Instruction Manual
- June 3, 2024
- VOLTCRAFT
Table of Contents
VOLTCRAFT 2176717 Power Bank
Intended Use
The product is a portable power bank with fast charging, and can supply up to
18 W of power. The built-in rechargeable battery is charged via USB. The
product is protected against overcharging, over-discharging, and overload.
Contact with moisture must be avoided under all circumstances. For safety and
approval purposes, you must not rebuild and/or modify this product. If you use
the product for purposes other than those described above, the product may be
damaged. In addition, improper use can result in short circuits, fires,
electric shocks or other hazards. Read the instructions carefully and store
them in a safe place. Make this product available to third parties only
together with its operating instructions.
This product complies with the statutory national and European requirements.
All company names and product names are trademarks of their respective owners.
All rights reserved.
Delivery Content
- Power bank
- Micro USB cable (27 cm)
- USB-C® cable (27 cm)
- Operating instructions
Up-to-Date Operating Instructions
Download the latest operating instructions at
www.conrad.com/downloads or scan the QR
code shown. Follow the instructions on the website.
Explanation of Symbols
- The symbol with the lightning in the triangle is used if there is a risk to your health, e.g. due to an electric shock.
- The symbol with the exclamation mark in the triangle is used to indicate important information in these operating instructions. Always read this information carefully.
- The arrow symbol indicates special information and advice on operation.
Safety Instructions
Read the operating instructions carefully and especially observe the safety information. If you do not follow the safety instructions and information on proper handling in this manual, we assume no liability for any resulting personal injury or damage to property. Such cases will invalidate the warranty/guarantee.
a) General Information
- The device is not a toy. Keep it out of the reach of children and pets.
- Do not leave packaging material lying around carelessly. This may become dangerous playing material for children.
- Protect the appliance from extreme temperatures, direct sunlight, strong jolts, high humidity, moisture, flammable gases, steam and solvents.
- Do not place the product under any mechanical stress.
- If it is no longer possible to operate the product safely, take it out of operation and protect it from any accidental use. Safe operation can no longer be guaranteed if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
- Please handle the product carefully. Jolts, impacts or a fall even from a low height can dam-age the product.
- Consult an expert when in doubt about the operation, safety or connection of the appliance.
- Maintenance, modifications and repairs must only be completed by a technician or an au-thorised repair centre.
- If you have questions which remain unanswered by these operating instructions, contact our technical support service or other technical personnel.
b) Power Bank
- Make sure that the cable is not pinched, kinked or damaged by sharp edges.
- Never use the product immediately after it has been brought from a cold room into a warm one. The condensation that forms might destroy the product. Allow the product to reach room temperature before connecting it and putting it to use. This may take several hours.
- Never leave the product unattended during use.
- The housing warms up during use. Ensure that there is sufficient ventilation. Do not cover the housing!
- Do not store the product in a heated vehicle. Avoid excessive heat (max. 35 °C). Observe the information in the “Technical data” section.
- Store the product in a cool, dry place when it is not in use.
- Do not short-circuit the USB inputs/outputs.
c) Connected Devices
- Also observe the safety and operating instructions of any other devices which are connected to the product.
d) LiPo Rechargeable Battery
- The rechargeable battery is permanently built into the product and cannot be replaced.
- Never damage the rechargeable battery. Damaging the casing of the rechargeable battery might cause an explosion or a fire! Unlike conventional batteries/rechargeable batteries (e.g. AA or AAA type), the casing of the LiPo rechargeable battery does not consist of a thin sheet but rather a sensitive plastic film only.
- Never short-circuit the contacts of the rechargeable battery. Do not throw the battery or the product into fire. There is a danger of fire and explosion!
- Charge the rechargeable battery regularly, even if you do are not using the product. Due to the rechargeable battery technology being used, you do not need to discharge the recharge-able battery first.
- Never charge the rechargeable battery of the product unattended.
- When charging, place the product on a surface that is not heat-sensitive. It is normal that a certain amount of heat is generated during charging.
- Do not charge the power bank and charge any external devices at the same time! This may result in damage due to overheating.
- Do not charge the power bank using a USB 2.0/3.0 port on your computer. The current supplied by these ports may not be sufficient, and may damage the computer.
Operating Elements
Item No. 2176717 shown below:
- LED battery status indicators
- Power button
- Press once to show the battery status.
- Press twice to deactivate the output power. 3 Micro USB input
- USB-A output 1
- USB-C® input/output
- USB-A output 2, fast charge (orange)
Charging the Power Bank
- Connect an included cable into the Micro USB input (3) or the USB-C® input (5) on your power bank.
- Connect the other end of the cable to a suitable USB power source.
LED Battery Status Indicators
The LED battery status indicators (1) show you how much power is left in the bank. If needed press the power button (2) once to light the indicators up. Each LED represents 25 % of charge.
Charging Mobile Devices
- Connect the included charging cable or mobile device cable to a charging output port.
- The LED battery status indicators will turn off after all devices have been disconnected from the charger.
- You can charge up to 3 devices at the same time. The total charging output is 18 W maximum and will be shared between each connected device.
Resetting
Reset the power bank if it does not work properly.
- Disconnect all devices from the power bank.
- Press and hold the power button for 9-10 seconds to activate the resetting mode. The indicator light flashes.
- Charge the power bank for several seconds.
The power bank is reset and ready to charge connected devices again.
Care and Cleaning
- Disconnect the product from any devices and power supply before cleaning.
- Do not use any aggressive cleaning agents, rubbing alcohol or other chemical solutions as they can cause damage to the housing and malfunction.
- Clean the product with a dry, fiber-free cloth.
Disposal
a) Product
This symbol must appear on any electrical and electronic equipment placed
on the EU market. This symbol indicates that this device should not be
disposed of as unsorted municipal waste at the end of its service life. Owners
of WEEE (Waste from Electrical and Electronic Equipment) shall dispose of it
separately from unsorted municipal waste. Spent batteries and accumulators,
which are not enclosed by the WEEE, as well as lamps that can be removed from
the WEEE in a non-destructive manner, must be removed by end users from the
WEEE in a non destructive manner before it is handed over to a collection
point.
Distributors of electrical and electronic equipment are legally obliged to provide free take-back of waste. Conrad provides the following return options free of charge (more details on our website):
- in our Conrad offices
- at the Conrad collection points
- at the collection points of public waste management authorities or the collection points set up by manufacturers or distributors within the meaning of the ElektroG
End users are responsible for deleting personal data from the WEEE to be disposed of. It should be noted that different obligations about the return or recycling of WEEE may apply in countries outside of Germany.
b) (Rechargeable) batteries
Remove batteries/rechargeable batteries, if any, and dispose of them
separately from the product. According to the Battery Directive, end users are
legally obliged to return all spent batteries/rechargeable batteries; they
must not be disposed of in the normal household waste. Batteries/rechargeable
batteries containing hazardous substances are labelled with this symbol to
indicate that disposal in household waste is forbidden. The abbreviations for
heavy metals in batteries are: Cd = Cadmium, Hg = Mercury, Pb = Lead (name on
(rechargeable) batteries, e.g. below the trash icon on the left). Used
(rechargeable) batteries can be returned to collection points in your
municipality, our stores or wherever (rechargeable) batteries are sold. You
thus fulfil your statutory obligations and contribute to environmental
protection. Batteries/rechargeable batteries that are disposed of should be
protected against short circuit and their exposed terminals should be covered
completely with insulating tape before disposal. Even empty
batteries/rechargeable batteries can contain residual energy that may cause
them to swell, burst, catch fire or explode in the event of a short circuit.
Technical Data
a) General
- Input voltage/current ………………………… Micro USB: 5 V 2 A USB-C®: 5 V 3 A; 9 V 2 A; PD 18 W max
- Output voltage/current ……………………… USB-A output 2 (orange): 5 V 3 A; 9 V 2 A; 12 V 1.5 A USB-A output 1: 5 V 2.4 A
- USB-C® input/output …………………………5 V 3 A; 9 V 2 A; PD 18 W max.
- Operating/Storage conditions …………….0 to +45 ºC, < 80 % RH (non-condensing)
b)Item No. 2176717
- Battery ……………………………………………LiPo 10000 mAh 37 Wh
- Charging time (empty to full) …………….. Micro USB: 5 V 2 A (6.3 hrs)
- Type-C®: 5 V 3 A (4.2 hrs)
- Type-C®: PD 18 W (3 hrs)
- Dimensions (L x W x H) …………………….135 x 69 x 15 mm
- Weight ……………………………………………190 g
c) Item No. 2176718
- Battery ……………………………………………LiPo 20000 mAh 74 Wh
- Charging time (empty to full) …………….. Micro USB: 5 V 2 A (12.5 hrs)
- Type-C®: 5 V 3 A (8.3 hrs)
- Type-C®: PD 18 W (5.5 hrs)
- Dimensions (L x W x H) …………………….140 x 69 x 27 mm
- Weight ……………………………………………366 g
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com). All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data processing systems require prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represent the technical status at the time of printing. Copyright 2022 by Conrad Electronic SE.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>