LEVITON BL-IS1001 Cable Suspended System Kit Instruction Manual
- June 15, 2024
- Leviton
Table of Contents
BL-IS1001 Cable Suspended System Kit
Instruction Manual
Installation Instructions
For Use With BWA250 w/ Cable Suspended System
WARNING
Risk of electrical shock. Disconnect power before servicing or installing
luminaire.
WARNING
Risk of injury or damage. Luminaire will fail if not installed properly.
Follow installation instructions.
WARNING
Risk of injury. Wear safety glasses and gloves during installation and
servicing. Allow ample time to cool before handling.
IMPORTANT SAFETY INSTRUCTIONS
- Read all installation instructions before installing. It is important to save these instructions.
- Only install and connect LED module/boards with power disconnected at the circuit breaker. Hot plugging, or connecting the LED module/ board with power on, could damage the LEDs and is not covered by warranty.
- Connectors on modules/boards and approved housings are keyed for specific voltage combinations; do not force or attempt to bypass connectors.
- Observe and follow all label information and instructions regarding dry, damp and wet location listings, proper Intense LED module, warnings of installation near combustible materials and/or insulation.
- Turn off power at circuit breaker before attempting to install or perform maintenance on the fixtures.
- Be sure to connect ground wire to prevent electric shock or other potential hazards.
- The product must be installed in a manner consistent with the intended use and in compliance with the national electrical codes and local codes by a person familiar with the construction and operation of the product and the hazards involved.
- Do not block the trim aperture as this may cause unsafe operating conditions.
- WARNING: RISK OF FIRE. Non-IC fixture requires that insulation must be kept at least 3” away from all sides of the fixture. Minimum of 90°C supply conductors. Consult a qualified electrician before installation.
Nominal Length| Length| Overall (in) Width| Height| CSS
Mounting Centers (in)
---|---|---|---|---
4ft| 47| 2.65| 10| 45.5625
6ft| 69.25| 67.8125
8ft| 91.5| 90.0625
CABLE GRIPPER INSTALL:
- Attach the bracket bar to the mud ring, or in the case of the “NC” option, mount the 1/4-20 stud to the structure and install the cable gripper.
CABLE INSTALL :
- Pass the cable end through the coupler and canopy before inserting it into the cable gripper. Pull excess cable out of J-box and trim to desired length.
Power feed & Canopy Setup (Contused):
POWER CABLE ASSEMBLY:
- Insert Power cord through canopy and secure with provided strain relief
- Note: For No Canopy option, Power needs to run in to a J-Box (by others) using provided 1/2” strain relief
- Complete wire make-up
- Install canopy with canopy mounting coupler
BIRCHWOOD LIGHTING | 3340 E La Palma Ave, Anaheim, CA 92806 |
tel 714 550-7118 | fax 714 550-7151 |
www.birchwoodlighting.com
For Birchwood Lighting’s limited product warranty, go to
www.birchwoodlighting.com. For a printed
copy of the warranty, you may call 800 961-5321.
© 2023 Birchwood Lighting, Inc. All rights reserved. Note: This document is
subject to change without notice.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>