Q-TRAN QTM-eLED-300W+WD-AWN-3 LED Power Supply And Control Installation Guide
- June 13, 2024
- Q-TRAN
Table of Contents
Q-TRAN QTM-eLED-300W+WD-AWN-3 LED Power Supply And Control Installation
Guide
WARNING
Risk of Fire / Electric Shock Transformer should be installed by a Licensed
electrician in accordance with the N.E.C. and all local codes in force.
Must be installed by licensed electrician.
- Wear rubber shoes and work on a sturdy wooden or fiberglass ladder.
- This power supply must be installed according to the National Electric
- Code and local codes and ordinances.
- This power supply is to be installed and serviced only by an licensed electricians.
- This power supply is to be installed so that it is not likely to be contacted by people.
- To avoid a hazard to children, account for all parts and destroy all packaging materials.
- Do not install in wet locations.
LOW VOLTAGE LIGHTING SYSTEM CLASS :
3425-15
3425-95
Node And Conduit Entry Locations
**RECESSED MOUNT
ISO VIEW**
SURFACE MOUNT
NOTE: AWN-3 is available for QTM-eLED+WD and QTM-eLED+0-10V only.
Conduit Entry Location
Athena nodes must be installed on the secondary side of power supply center
and require 1.0” of clearance in order to optimally function. Metal conduit
must be 1.0” away from any node. Refer to the diagram above for
recommendations for conduit entry into secondary compartment.
Lutron Athena Node
Mounted in the secondary wiring compartment only
Mounting Options
NOTE: Bracket can also be mounted (Top & Bottom) for Vertical Mounts.
ROD SUSPENSION (Vertical)
**ROD SUSPENSION (Horizontal)
**
SURFACE SPACING
**URFACE STACKING
**
ROD SUSPENSION
Vertical
Plenum Door Required
**Horizontal
**
NOTE: Rods not included.
Driver with Lutron Athena Node
QTM-eLED-300W+WD-AWN-3
CSA Requirements
- Suitable for indoor use
- This power supply must be installed according to the National Electric Code and local codes and ordinances and in accordance with applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
- Wear rubber shoes and work on a sturdy wooden or fiberglass ladder.
- This power supply is to be installed in a location where it is not likely to be contacted by non-electricians.
- To avoid a hazard to children, account for all parts and destroy all packaging materials.
© 2023 Q-Tran Inc. All rights reserved
155 Hill St. Milford, CT 06460
203-367-8777
sales@q-tran.com
www.q-tran.com
References
- Your Name as Your Email | Hover Realnames
- LED Lighting Systems, Linear LED Lights, LED transformers | Q-Tran
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>