Q-TRAN QTM-eLED-ND LED Power Supply Installation Guide
- May 15, 2024
- Q-TRAN
Table of Contents
INSTALLATION LED POWER SUPPLY – QTM-eLED-ND
Housing
ISOMETRIC VIEW BOTTOM VIEW
- 0.875″ KNOCKOUT 9X (FOR 1/2″ FITTINGS)
NOTE: Bracket can also be mounted (Top & Bottom) for Vertical Mounts.
- 1/4″ Rod Thru Hole
- 3/8″ Rod Thru Hole
- Double Sided Key Hole
Mounting Options
-
HORIZONTAL
-
VERTICAL
-
RECESSED MOUNT
-
RECESSED
-
SURFACE
-
ROD SUSPENSION
(Horizontal) -
ROD SUSPENSION
(Vertical)
NOTE: Rods
not included.
- SURFACE SPACING
- SURFACE STACKING
- ROD SUSPENSION
- Vertical
- Horizontal
a: More Units can be stacked
b: Plenum Door Required
Driver with Dimming Module
QTM-eLED
: for interior
- LED DRIVER (120V – 277V)
- SECONDARY
- PRIMARY
- Negative
- Positive
CSA Requirements
- Suitable for Indoor use
- This power supply must be installed according to the National Electric Code and local codes and ordinances and in accordance with applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
- Wear rubber shoes and work on a sturdy wooden or fiberglass ladder.
- This power supply is to be installed in a location where it is not likely to be contacted by non-electricians.
- To avoid a hazard to children, account for all parts and destroy all packaging materials.
| QTM-eLED | INPUT VOLTAGE | OUTPUT VOLTAGE | CONTROL TYPE |
|---|---|---|---|
| 120V – 277V | 12V | 24V | 0-10V |
DMX
WD
TW
ND
| Model| Input Voltage (V)| Input Current (A)| Frequency| Nominal Output Voltage (VDC)| Nominal Output Wattage (W)
QTM-eLED-60
QTM-eLED-120
QTM-eLED-180
QTM-eLED-100
QTM-eLED-200
QTM-eLED-300
|
120 / 277
120 / 277
120 / 277
120 / 277
120 / 277
120 / 277
|
0.60 / 0.29
1.20 / 0.58
1.80 / 0.87
0.95 / 0.40
1.90 / 0.80
2.85 / 1.20
|
50/60
50/60
50/60
50/60
50/60
50/60
|
12
12
12
24
24
24
|
60
120
180
100
200
300
• Type Ic Recessed, Inherently Protected Type IC ENCASTRE, PROTECTION
INHÉRENTE
• For Supply Connections Use Wire Rated For At Least 60 C.
• Not for use with dimmers NE CONVIENT PAS A DES GRADATEURS
• Suitable For Damp Locations CONVIENT AUX EMPLACEMENTS HUMIDES
• 50/60 Cycle
• Class 1 or Class 2This product must be installed in accordance with the
applicable installation code by a person familiar with the construction and
operation of the product and the hazards involved.
LOW VOLTAGE
LIGHTING SYSTEM
Q-Tran, Inc.
CLASS: 3425 – 15 3425 – 95
Q-TRAN, INC.
MILFORD, CT U.S.A.
203-367-8777
WWW.Q-TRAN.COM
© 2023 Q-Tran Inc. All rights reserved | 155 Hill St. Milford, CT 06460 | 203-367-8777 | sales@q-tran.com | www.q-tran.com
Specification subject to change. Rev-10-03-23
References
- Your Name as Your Email | Hover Realnames
- LED Lighting Systems, Linear LED Lights, LED transformers | Q-Tran
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>