Q-TRAN QOM-eLED+WD-PS LED Power Supply Installation Guide
- June 3, 2024
- Q-TRAN
Table of Contents
Q-TRAN QOM-eLED+WD-PS LED Power Supply
Housing
Mounting Options
NOTE : To order additional lengths of wire for connection in the secondary Please call factory for availability. : QOM must be installed as shown.
Wiring Installation
Swimming Pool Installation
In accordance with the requirements of NEC680 regulation in the United States, when an illumination light is installed in the swimming pool, the distance from the bottom of the terminal box to the ground shall be no less than 4 inches. The vertical distance to the water surface of the swimming shall not be less than 8 inches, and the horizontal distance to the water edge of the swimming pool shall not be less than 48 inches.
REQUIREMENT FOR POWER SUPPLY
Please use only an isolating low-voltage power supply with ungrounded output,
evaluated for swimming pool use.
Fundamental Construction
All the fundamental constructions, including the installation of the junction box and switch, cable bushing and laying, the digging of slots, etc., should be done before the light installation.
CSA Requirements
- Power unit for use with Fountain, Swimming Pool, and Spa Luminaires
- Suitable for indoor and outdoor use
- This power supply must be installed according to the National Electric Code and local codes and ordinances and in accordance with applicable installation codes by a person familiar with the construction and operation of the product and the hazards involved.
- Wear rubber shoes and work on a sturdy wooden or fiberglass ladder.
- This power supply is to be installed in a location where it is not likely to be contacted by non-electricians.
- To avoid a hazard to children, account for all parts and destroy all packaging materials.
- Keep the enclosure cover covered.
References
- Your Name as Your Email | Hover Realnames
- LED Lighting Systems, Linear LED Lights, LED transformers | Q-Tran