THERMALRIGHT AXP90-X47 Full Low Profile Desktop CPU Cooler Installation Guide
- June 13, 2024
- THERMALRIGHT
Table of Contents
THERMALRIGHT AXP90-X47 Full Low Profile Desktop CPU Cooler Installation
Guide
parts list
-
A Heatsink x1
-
B Bracket’2+2 + screw *4
-
C Backplane x1
-
D thermal Greasa x1
-
E Nut x1 +tool x1
INTEL LGA 115X /1200
Remove the pre-installed nut X4. back plate on the radiator; CPU apply the
heat conduction paste to push the four support screws of the radiator through
the main board hole and press the CPU
Install backplane on the back of the motherboard, and pay attention to the
backplane direction: AM4 is the sticker Close the main board surface, and use
the nut auxiliary ool o fix the screw on the bottom of the main board. Pay
attention (o the direction that the back board fits the main board, and the
insulation sheet must be pasted.If there is power supply interference on the
back of the motherboard, please use B1 long screw install the backplane
reversely. LGA 115 s to it the motherboard surface, and fix the nuts on the
bottom screw of the motherboard.
INTEL LGA 1700
Remove the pre installed back plate of the radiator and the support of
Iga115x, and replace the double head screws of Iga115x, On the Iga1700
bracket, coat the CPU with heat transfer paste, and press the pre locked
radiator according to the corresponding The hole position is installed on the
main board
Install backplane on the back of the motherboard, and pay attention o the
backplane direction: AM4 is the sticker Close the main board surface, and use
the nut auxiliary tool o fix the screw on the bottom of the main board. Pay
attention to the direction that the back board fits the main board, and the
insulation sheet must be pasted.If there is power supply interference on the
back of the motherboard, please use B1 long screw nstall the backplane
reversely. LGA 115x is o fit the motherboard surface, and fix the nuts on the
bottom screw of the motherboard.
AMD AM4
Remove the original plastic support and back plate of main board with
screwdriver, remove the pre installed nut x4. back plate, support x2. on
radiator
The distribution support x2 is x2 through the copper bottom of the radiator
with four small screws, the distribution support x2 is fixed with the
radiator, the heat conduction paste is applied CPU, and the four support
screws of the radiator are pressed through the copper bottom of the radiator
in the main board hole CPU. pressed
Install backplane on the back of the motherboard. The backplane direction: LGA
115x is to fit the motherboard surface. Use the nut auxiliary tool to fix the
screws on the bottom of the motherboard. Pay attention to the direction of the
backplane sticking to the motherboard, the insulation sheet must be pasted
Fan wiring installation
- If there is power supply interference on the back of the motherboard, please install the backplane reversely. LGA 115x s to fit the motherboard surface, and fix the nuts on the bottom screw. of the motherboard.
- Insert fan 4-pin connector into main board CPU_FAN4 pin socket
Reminder
- Remove the copper bottom protective film before using the radiator.
- Pay attention to the fitting direction of the backplane and the motherboard.
- 0ne side of the back board pasted with insulating sheet is in the direction of the main board
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>