THERMALRIGHT FC140 CPU Cooler Dual Towers And Dual Fan Installation Guide
- June 13, 2024
- THERMALRIGHT
Table of Contents
INSTALLATION GUIDE
TR-Frost Commander 140
Series
www.thermalright.com
Accessories list
AMD AM4
Remove AMD’s original
plastic bracket and retain the backplane; Use AM4 glue column to lock the
original mainboard base plate
Apply thermal paste, lock
the main body with a screwdriver, and secure the fan with a cable tie
INTEL LGA115X
Install the backplane into the 115X hole as shown in the picture and then jam it with the 0-shaped plastic pad. Then place the backplane on the back of the motherboard, tighten the studs, and secure the support with screws (the support hole is aligned with 115X).
Apply thermal paste, lock the main body with a screwdriver, and secure the fan with a cable tie
INTEL LGA20XX
Screw the LGA20XX studs onto motherboard place the bracket and secure the INTEL bracket with nuts.
Apply thermal paste, lock the main body with a screwdriver, and secure the fan with a cable tie
LGA1700
Install the backplane into 1700 holes as shown in the picture and then jam it with o-shaped plastic pad. Then place the backplane on the back of the motherboard, tighten the studs, and fix the support with screws (the support hole is aligned with 1700).
Apply thermal paste, lock the main body with a screwdriver, and secure the fan with a cable tie
Fan wiring
Insert the FAN 4-pin into the CPU FAN socket on the motherboard and use the Y-type adapter cable. If the FAN supports RGB, Insert the fan 4-pin light line into the 12V 4P RGB socket on the mainboard, and the fan is in series