THERMALRIGHT FS140 CPU Cooler With 4 Heatpipes PWM Dual Fan Installation Guide
- June 13, 2024
- THERMALRIGHT
Table of Contents
INSTALLATION GUIDE
TR-Frost Spirit 140 Series
FS140 CPU Cooler With 4 Heat pipes PWM Dual Fan
Accessories list
AMDAM4
Remove AMD’s original plastic bracket and retain the backplane; Use AM4 glue column to lock the original mainboard base plate
Apply thermal paste, lock the main body with a screwdriver, and secure the fan with a cable tie
INTEL LGA115X
Install the backplane into the 115X hole as shown in the picture and then jam it with the O-shaped plastic pad. Then place the backplane on the back of the motherboard, tighten the studs, and secure the support with screws (the support hole is aligned with 1150
Apply thermal paste, lock the main body with a screwdriver, and secure the fan with a cable tie
INTEL LGA20XX
Screw the LGA20XX studs onto the motherboard, place the bracket, and secure the INTEL bracket with nuts.
Apply thermal paste, lock the main body with a screwdriver, and secure the fan with a cable tie
LGA1700
Install the backplane into 1700 holes as shown in the picture and then jam it with o-shaped plastic pad. Then place the backplane on the back of the motherboard, tighten the studs, and fix the support with screws (the support hole is aligned with 1700).
Apply thermal paste, lock the main body with a screwdriver, and secure the fan with a cable tie
Fan wiring
Insert the FAN 4-pin into the CPU FAN socket on the motherboard and use the Y-type adapter cable. If the FAN supports RGB, Insert the fan 4-pin light line into the 12V 4P RGB socket on the mainboard, and the fan is in series
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>