GENERATION LIGHTING 3187204 Baker Four Light Small Chandelier Instruction Manual
- June 13, 2024
- GENERATION LIGHTING
Table of Contents
Installation Instructions for
Baker Chandelier
CHANDELIER
990CH3_87204-BKR
3187204, 3287204
1.1
SAVE THESE INSTRUCTIONS!
GENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing compliant junction
boxes.
This product is safety listed for damp locations.
Incandescent version may be dimmed with a standard incandescent dimmer.
LED version may be dimmed with a LED dimmer. Consult lamp manufacturer for
additional information.
This instruction shows a typical installation.
CAUTION RISK OF FIRE
This product must be installed in accordance with the applicable
installation code by a person familiar with the construction and operation of
the product and the hazards involved.
Use minimum 90°c supply conductors.
Install the Fixture
- Feed the fixture wires through the top cup and spacer, and thread the spacer onto the threaded nipple.
- Determine the wanted height or look of the fixture with the provided stems, swivel, and/or chain and assemble them by screwing them together. NOTE: Use hang straight for standard ceilings and use link and loop for sloped ceilings.
- Feed the fixture wires through the stem/hang straight or link and loop assembly and screw the assembly to the fixture.
- Unscrew the collar nut off the screw collar and place it onto the stem/hang straight or link and loop assembly followed by the canopy.
- Screw the screw collar onto the threaded nipple.
- Feed the fixture wires through the threaded nipple and screw the mounting plate assembly onto the hang straight or link and loop.
- Align and secure the mounting plate to the junction box.
- Connect the fixture to a suitable ground in accordance to local electrical codes.
- Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
- Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
- Neatly place all the wires into the junction box, place the canopy onto the ceiling and secure it in place with the collar nut.
- Install the fixture finial by screwing it on to the lower threaded nipple.
- Screw the lamp into the socket. Refer to the label on the socket for Max Wattage Information.
- Install the shades by placing them over the lamps.
©2022 Visual Comfort & Co., L.L.C. All rights reserved. The Visual Comfort &
Co. logo is a registered trademark of Visual Comfort & Co.
Visual Comfort & Co. reserves the right to change specifications for product
improvements without notification.
7400 Linder Ave., Skokie, IL 60077
T 847.410.4400 | F 847.410.4500
www.generationlighting.com
Visual Comfort & Co.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>