GENERATION LIGHTING 4457104EN3-112 Oak Moore Vanity Light Instruction Manual
- June 12, 2024
- GENERATION LIGHTING
Table of Contents
GENERATION LIGHTING 4457104EN3-112 Oak Moore Vanity Light
Product Information
The Oak Moore Wall is a fixture designed for installation in damp locations. It is intended to be installed using NEC compliant junction boxes. The product is available in multiple variants: 4157101, 4457102, 4457103, and 4457104.
Product Usage Instructions
- Secure the mounting plate to the junction box or wall.
- Connect the fixture to a suitable ground according to local electrical codes.
- Connect the white fixture wire to the neutral power line wire using a wire nut.
- Connect the black fixture wire to the hot power line wire using a wire nut.
- Neatly place the wires into the junction box and position the fixture onto the mounting studs. Secure it in place by screwing the cap nuts onto the studs.
- Place the shade over the socket and onto the shade base. Secure it in place by screwing the collar nut onto the socket. Repeat this step for any remaining shades.
- Screw the lamp(s) into the socket(s). Refer to the label on the socket for maximum wattage information.
Note: It is important to follow all applicable installation codes and ensure that the installation is carried out by someone familiar with the construction and operation of the product and the associated hazards. Please save these instructions for future reference.
GENERAL PRODUCT INFORMATION
- These fixtures are intended to be installed utilizing NEC-compliant junction boxes.
- This product is safety listed for damp locations.
- This instruction shows a typical installation.
CAUTION – RISK OF FIRE
This product must be installed in accordance with the applicable installation
code by a person familiar with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
Install the Fixture
Install the Fixture
-
Secure the mounting plate to the junction box or wall.
-
Connect the fixture to a suitable ground in accordance with local electrical codes.
-
Connect the white fixture wire to the neutral power line wire with a wire nut.
-
Connect the black fixture wire to the hot power line wire with a wire nut.
-
Neatly place the wires into the junction box, place the fixture onto the mounting studs, and secure it in place by screwing the cap nuts onto the studs.
-
Place the shade over the socket and onto the shade base, then secure it in place by screwing the collar nut onto the socket.
Repeat for remaining shades. -
Screw the lamp(s) into the socket(s). Refer to the label on the socket for Max Wattage Information.
GENERATION LIGHTING
7400 Linder Ave., Skokie, IL 60077
T 847.410.4400 | F 847.410.4500
www.generationlighting.com
©2022 Visual Comfort & Co., L.L.C. All rights reserved. The Visual Comfort &
Co. logo is a registered trademark of Visual Comfort & Co.
Visual Comfort & Co. reserves the right to change specifications for product
improvements without notification.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>