GENERATION LIGHTING WALL 4164201, 4464202, 4464203, 4464204 Fullton Wall Instruction Manual
- October 30, 2023
- GENERATION LIGHTING WALL
Table of Contents
Installation Instructions for
Fullton Wall
4164201, 4464202, 4464203, 4464204
GENERAL RODUCT NFORMATION:
These fixtures are intended to be installed utilizing NEC compliant junction
boxes.
This product is safety listed for damp locations.
This instruction shows a typical installation.
CAUTION RISK OF FIRE
This product must be installed in accordance with the applicable installation
code by a person familiar with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
SAVE THESE INSTRUCTIONS!
Install the Fixture
- Secure the mounting plate to the junction box or wall.
- Connect the fixture to a suitable ground in accordance with local electrical codes.
- Connect the white fixture wire to the neutral power line wire with a wire nut.
- Connect the black fixture wire to the hot power line wire with a wire nut.
- Neatly place the wires into the junction box, place the fixture onto the mounting studs, and secure it in place by screwing the cap nuts onto the studs.
- Place the shade over the socket and onto the shade base, then secure it in place by screwing the collar nut onto the socket. Repeat for remaining shades.
- Screw the lamp(s) into the socket(s). Refer to the label on the socket for Max Wattage Information.
©2022 Visual Comfort & Co., L.L.C. All rights reserved. The Visual Comfort &
Co. logo is a registered trademark of Visual Comfort & Co.
Visual Comfort & Co. reserves the right to change specifications for product
improvements without notification.
7400 Linder Ave., Skokie, IL 60077
T 847.410.4400
F 847.410.4500
www.generationlighting.com