maytronics S100 Robotic Pool Cleaner User Guide

maytronics S100 Robotic Pool Cleaner

Thank you for purchasing a Medtronic’s Robotic Pool Cleaner.

The Robotic Pool Cleaners by Medtronic’s deliver advanced cleaning technology’s, long lasting performance and easy maintenance. You and your family will be free to enjoy swimming with full confidence that your pool is completely clean.

Cautions & Warnings

• Use the originally supplied power supply only.
• Do not use an extension cable in any case whatsoever.
• Ensure the electrical outlet is protected by a ground fault interrupter (GFI) or an earth leakage interrupter.
• Keep the power supply out of standing water.
• Do not enter the pool while the Pool Cleaner is working.
• Unplug the power supply before servicing.
• Do not pull the Pool cleaner from the pool using the cable.
• Use the Pool Cleaner in the following water conditions only: Chlorine Max 4 ppm; pH 7.0 – 7.8; Temperature 6 -34°C (43-93°F); NaCl Maximum = 5000 ppm.
• Specifications:
  Motor protection: IP 68
  Minimum depth: 0.80m/2.6ft
  Maximum depth: 5m/16.4ft

Helpful hints

• When working, the Power Supply should be placed in the shade.
• If the Dolphin is fitted with combined or wonder brushes, gently acquiesce the brushes until they are soaked with water.
• Release minimal required floating cable length to ensure proper pool coverage. Leave excess cable rolled outside the pool.
• After each cleaning cycle wash the filter bag or cartridge. Clogged filter bags reduce scanning and cleaning efficiency.
• Once a week unplug the cable from the power supply, unwind the tangled portions of the cable, straighten it out and leave it in the sun for several houres.
• Store the pool cleaner in a shady place on its Caddy, if not on a caddy, place the pool cleaner upside down.

For a detailed manual (including videos): manuais.maytronics.com/99996121-TH

Robot operation

Set Up

Attach the floating cable to the power supply.

Position the power supply at least 3m/1 Oft away from the edge of the pool.

Into the pool

Put the Pool Cleaner into the pool.
Release the Pool Cleaner and let it sink to the floor of the pool.
Make sure that the floating cable is free of any obstructions.

Operation

Turn the power supply O N.
The Pool Cleaner will now operate until it has reached the end of the cleaning cycle .

Out of the pool

Cleaning the filter

It is highly recomended to clean the filter basket after each cleaning cycle .
Note: Don’t let the filter cartridges dry out before cleaning .

Unplug the power supply before servicing

Open the filter cover.

Lift up the basket.

Open the latch to release the bottom lid in order to remove the debris.

Clean the filter basket with a hose .

Storage

Coil the cable and store in a cool, dry place on the Caddy.
Do NOT store the robot where it will be exposed to direct sunlight, excessive heat or to frost.

Maintenance

Periodic filter cleaning

Dismantle the 2 ultra-fine filter panels of the outer basket according to the following steps:

Dismantle the 2 panels using your thumbs.

Clean the filter panels with a hose.

Assemble the filter panels.

Insert the clean filter basket and close the filter cover.

Cleaning the impeller

If you notice debris trapped in the impeller:

Unplug the power supply before servicing Clean the debris trapped in the impeller opening, according to the following steps:

If the debris is not reachable follow the next steps.

Using a short screwdriver open the 2 screws.

Pull the impeller cover backwards to release it. Clean the debris trapped around the impeller. Assemble the impeller cover.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>