GENERATION LIGHTING 591320S Drop LED Lens Installation Guide

GENERATION LIGHTING 591320S Drop LED Lens

ENERAL RODUCT NFORMATION

• These fixtures are intended to be installed utilizing compliant junction NEC boxes.
• This product is safety listed for damp locations.
• This fixture may be dimmed with a low-voltage electronic dimmer.
• This instruction shows a typical installation.

CAUTION RISK OF FIRE
This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. Use minimum 90°c supply conductors.

Install the Fixture

1. Slide the end cap outward and remove the diffuser.
2. Connect the fixture to a suitable ground in accordance with local electrical codes.
3. Connect the white driver wire to the neutral power line wire with a wire nut.
4. Connect the black driver wire to the hot power line wire with a wire nut.
5. Neatly place all the wires into the junction box, align the fixture to the mounting holes and secure it in place with the fixture screws
6. Reinstall the diffuser and slide the end cap inward.

INTERNAL WIRING METHOD

1. Slide the end cap outward and remove the diffuser.
2. Carefully pull the reflector from one side to the middle to access inside the fixture.
3. Remove the wiring compartment cover by removing the two thumb nuts.
4. Remove the back knockout and bring power wires to fixture.
5. Position the fixture to the mounting surface and mark the screw hole locations at the narrow section of the keyholes.
6. Using the provided anchors and/or tapping screws, properly secure the fixture to the surface.
7. Connect the fixture to a suitable ground in accordance with local electrical codes.
8. Connect the white driver wire to the neutral power line wire with a wire nut.
9. Connect the black driver wire to the hot power line wire with a wire nut.
10. Place the wires and wire nut connections into the wiring compartment, reinstall the cover, and secure in place with the two thumb nuts.
11. Put the side of the reflector back to it’s original position.
12. Reinstall the diffuser and slide the end cap inward.

• 2022 Visual Comfort & Co., L.L.C. All rights reserved. The Visual Comfort & Co. logo is a registered trademark of Visual Comfort & Co. Visual Comfort & Co. reserves the right to change specifications for product improvements without notification.
• 7400 Linder Ave., Skokie, IL 60077 T 847.410.4400 | F 847.410.4500 www.generationlighting.com

References

• Generation Lighting Collection | Visual Comfort & Co.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>