RIGID 11-14073-A Revolve Light Pod or Light Bar Instruction Manual

June 13, 2024
RIGID

RIGID 11-14073-A Revolve Light Pod or Light Bar Instruction Manual

REVOLVE LIGHT POD AND LIGHT BAR

PRODUCTS INCLUDE:

  • Revolve Light (Pod or Light bar)
  • Mount Brackets and Hardware

THANK YOU FOR PURCHASING RIGID INDUSTRIES’ PRODUCTS FOR YOUR VEHICLE.

Please read through all of these Instructions and tips before proceeding with the installation.
We do our best to provide a simple installation process for all applications however a professional installation is always recommended.

  1. Revolve lights are designed to operate from 9V-36V only. Using this product on a 32V or higher system will cause permanent damage to electrical components.
  2. Back lighting and forward projecting LED’s are intended for off-road use only.

MOUNTING INSTRUCTIONS

Insert mounting brackets onto light as
shown below. Secure hardware to a
snug position and mount your light in
desired location.| Revolve light bars come pre-assembled
with the compression spacers installed,
please remove to add mount bolts.
---|---
A – 5/16” Nylon Locknut(1)
B – 5/16” Bolt (1)
C – Bracket (1)
D – Carriage Bolt (1)
Vehicle Mount Hardware
| A – 1/4” Nylon Locknut (2)
B – 1/4” Flat Washer (2)
C – Mounting Bracket (2)
D – Compression Spacer (2)
E – 1/4” Bolt (2)

SUGGESTED WIRING HARNESS

Includes:
(1) 3-Position Switch
(1) In-Line Fuse
(1) Relay
battery leads
| Includes:
(2) Switches,
(1) In-Line Fuse,
(1) Relay
battery leads

---|---

WIRING INSTRUCTIONS

POD
3-POSITION SWITCH


Match the light pigtail to the harness colors: Red to Red (Forward projecting LED +12v trigger), White to White (back-lighting LED +12v trigger), and Black to Black (shared ground).
Use butt connectors with appropriate wire AWG.| Find a desired location for switches and drill a 3/4” hole for each switch.
Connect leads from wire harness to switch using the following diagrams:

POD
3-POSITION SWITCH

BAR
FORWARD PROJECTING LED’S


BACK-LIGHTING LED’S

Route main power and ground leads from the harness to the battery terminals and attach the RED lead to battery +12v and the BLACK lead directly to the battery ground.| Reconnect the negative battery terminal and turn switches on to verify lights are functional.

Your installation is now complete.

WARRANTY INFORMATION

For warranty information, visit www.rigidindustries.com/about/warranty 779 N Colorado St, Gilbert, AZ 85233 ï 855-760-5337 www.rigidindustries.com
RIGID, Revolve and Rigid Industries are registered and/or common law marks owned by JST Performance, LLC, a Delaware limited liability company d/b/a Rigid Industries.
11-14073-A

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals