RIGID 2020+ Ford Super Duty Dual Fog Mount Kit Instruction Manual

June 12, 2024
RIGID

RIGID 2020+ Ford Super Duty Dual Fog Mount Kit

RIGID-2020+-Ford-Super-Duty-Dual-Fog-Mount-Kit-
PRODUCT

PRODUCTS INCLUDE

  • (1) Driver Side Bracket
  • (1) Passenger Side Bracket
  • Lights sold separately.

RECOMMENDED TOOLS

  • 8mm socket
  • 13mm socket
  • 15mm socket
  • T25 Torx

IMPORTANT

  • THANK YOU FOR PURCHASING RIGID INDUSTRIES’ PRODUCTS FOR YOUR VEHICLE.
  • Please read through all of these Instructions and tips before proceeding with the installation.
  • We do our best to provide a simple installation process for all applications however a professional installation is always recommended.
  • Always disconnect any power sources connected to your vehicle before servicing fuses or electrical systems.

INSTALLATION INSTRUCTIONS

STEP: 1

  • Disconnect the negative battery terminal before starting the install.
  • Remove 4 circled bolts with a 15mm socket to remove the protective plate. (Driver side shown)

STEP: 2

  • Remove the lower bolt and loosen the upper bolt with a 13mm socket. Unplug the fog light connector.

STEP: 3

  • For the LED Fog lamps (Platinum and Limited Models), remove the 4 circled screws with a T25 Torx on the back of the OEM fog light to separate the OEM fog light bracket and the fog light.
  • Pictured on the right, is the standard fog light on the Lariat and King Ranch models.
  • This does not require removing the 4 Torx screws.

STEP: 4

RIGID-2020+-Ford-Super-Duty-Dual-Fog-Mount-Kit-FIG-5

  • Remove the 4 circled bolts with an 8mm socket.
  • Then remove the fog light bracket and the light afterward.

STEP: 5

  • Remove the fog light bezel from the bumper.
  • Pinch the clips on the inside the bezel to unsnap it from the bumper.

STEP: 6

RIGID-2020+-Ford-Super-Duty-Dual-Fog-Mount-Kit-FIG-8

  • After removing the bezel, install the pods onto the bracket as shown below.
  • Reinstall the two upper bolts loosely with an 8mm socket.

STEP: 7

RIGID-2020+-Ford-Super-Duty-Dual-Fog-Mount-Kit-FIG-9

  • Next, install the front bezel with the supplied M5x0.8 button head bolts, nyloc’s and washers.RIGID-2020+-Ford-Super-Duty-Dual-Fog-Mount-Kit-FIG-10
  • Use a 3mm hex key to for the button head and an 8mm socket to tighten the nyloc’s.RIGID-2020+-Ford-Super-Duty-Dual-Fog-Mount-Kit-FIG-11
  • Now tighten down the two upper bolts with an 8mm socket.

STEP: 8

RIGID-2020+-Ford-Super-Duty-Dual-Fog-Mount-Kit-FIG-12

  • You’ve finished installing one side, repeat steps 1-7 on the opposite side.

Wiring

  • Wire your lights according to the instructions included with the light. Take care to avoid any heat sources and sharp or abrasive surfaces.
  • Your installation is now complete.
  • Welcome to the Rigid Nation!

WARRANTY INFORMATION

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals