RIGID Rds Sr-Series Pro Bar Instruction Manual
- June 10, 2024
- RIGID
Table of Contents
RDS SR-SERIES PRO
INSTALLATION INSTRUCTIONS
Rds Sr-Series Pro Bar
IMPORTANT
THANK YOU FOR PURCHASING RIGID PRODUCTS FOR YOUR VEHICLE.
Please read through all of these Instructions and tips before proceeding with
the installation.
We do our best to provide a simple installation process for all applications
however a professional installation is always recommended.
Always disconnect any power sources connected to your vehicle before servicing
fuses or electrical systems.
RDS SR-SERIES PRO
Mounting your light bar: Assemble mounting hardware onto the light bar as
shown in Figure 1. (The mount bushings are designed to clip in, holding the
bolts in place.) If using the short L-brackets, it is recommended that you
mark the location of your mounting holes using the assembly, drill the
mounting holes, then mount the light bar in its final location, using hardware
of your choice.
WIRING INSTRUCTIONS
IMPORTANT
Always disconnect any power sources connected to your vehicle before servicing
fuses or electrical systems.
- Reference Figure 2.
- Locate a suitable, “high and dry” location to mount the relay, close to the vehicle battery, in the engine compartment.
- When routing wire harness through the vehicle firewall (or any sheetmetal panel), make sure there are no sharp edges that could damage your harness. Protect the harness from damage by using a grommet and/or loom and tape.
- Route the light bar, switch, and battery harnesses through the vehicle to their general locations.
- Switch should be mounted in cab. Route the switch leads to desired dash location. Mount the switch. (Drilling + file-fitting may be required.) Connect wiring as shown in Figure 3.
- Connect light bar flying leads to positive and negative harness leads. (RED wire is positive, BLACK wire is negative.)
- Connect positive and negative battery terminals to vehicle battery. (RED wire is positive, BLACK wire is negative.)
- Test functionality and adjust / aim your lightbar.
- Tighten mounting hardware to 75 in-lbs. (~6 ft-lbs)
SWITCH WIRING
NOTE: GOLD Spade is the Top of Switch, 3/4” mounting hole required
SWITCH WIRING (SINGLE AND SETS)
– P1- Black Wire = Switch Ground
– P2 – Blue Wire/Red Wire w/ Heat Shrink = Switch Output to Relay
– P3 – Red Wire = Switch Input Power
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>