GENERATION LIGHTING C 1122 Perno Medium Semi Flush Mount Instruction Manual
- June 13, 2024
- GENERATION LIGHTING
Table of Contents
GENERATION LIGHTING C 1122 Perno Medium Semi Flush Mount
Product Information
- Model: PERNO_MED_FLUSH
- Product Code: CF1122 1.0
- Type: Flush Mount
General Product Information:
- Intended for installation using NEC compliant junction boxes
- Safety listed for damp locations
- Incandescent version can be dimmed with a standard incandescent dimmer
- LED version can be dimmed with a LED dimmer
- Consult lamp manufacturer for additional information
CAUTION – RISK OF FIRE:
This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
SAVE THESE INSTRUCTIONS!
7400 Linder Ave., Skokie, IL 60077 T 847.410.4400 | F 847.410.4500
Product Usage Instructions:
- Install the mounting plate to the junction box.
- Connect the fixture to a suitable ground in accordance with local electrical codes.
- Install a frame arm by inserting one end in the top hub and the other in the bottom hub.
- Secure the frame arm in place with a set screw located in the bottom hub. Use the provided Allen wrench to tighten the set screw.
- Repeat step 3 and 4 for all arms.
- Install the check ring onto the threaded nipple and screw the finial in place.
ENERALGPRODUCT INFORMATION
- These fixtures are intended to be installed utilizing NEC-compliant junction boxes.
- This product is safety-listed for damp locations.
- The incandescent version may be dimmed with a standard incandescent dimmer. LED version may be dimmed with a LED dimmer. Consult lamp manufacturer for additional information.
- This instruction shows a typical installation.
CAUTION – RISK OF FIRE
This product must be installed in accordance with the applicable installation
code by a person familiar with the construction and operation of the product
and the hazards involved.
Use minimum 90°C supply conductors.
SAVE THESE INSTRUCTIONS!
Install the Fixture
- Install the mounting plate to the junction box.
- Connect the fixture to a suitable ground in accordance with local electrical codes.
- Connect the white fixture wire to the neutral power line wire with a wire nut.
- Connect the black fixture wire to the hot power line wire with a wire nut.
- Neatly tuck the wiring into the junction box, place the fixture base onto the mounting plate and secure it in place with the fixture screws.
- Screw the lamps into the sockets. Refer to the label on the socket for max wattage information.
- Screw the short end of the threaded rod into the socket assembly.
- Place the shade, then the diffuser onto the threaded rod and secure in place by screwing the bottom hub onto the threaded pipe.
- Install a frame arm by inserting one end in the top hub and the other in the bottom hub, then secure it in place with a set screw, using the provided Allen wrench, in the bottom hub. Repeat for all arms.
- Install the check ring onto the threaded nipple and screw the finial in place.
7400 Linder Ave., Skokie, IL 60077 T 847.410.4400 | F 847.410.4500 www.generationlighting.com
©2022 Visual Comfort & Co., L.L.C. All rights reserved. The Visual Comfort & Co. logo is a registered trademark of Visual Comfort & Co. Visual Comfort & Co. reserves the right to change specifications for product improvements without notification.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>