CARVEN EXHAUST CR1004 Direct Fit Muffler Replacement Progressive Instructions
- June 13, 2024
- CARVEN EXHAUST
Table of Contents
CARVEN EXHAUST CR1004 Direct Fit Muffler Replacement Progressive
Clamp Specs
Place top of clamp over non perforated section of tube, then slide clamp down
to the slit section. Torque clamp bolt to
Step
- Loosen clamps on OEM muffler (do not remove, these are welded in place)
- Continue removing OEM exhaust & hanger grommets
- Spray lubricant on exhaust hanger for easier removal
Step
- Disconnect the tailpipes and safely remove them
- Unhook rubber grommet from the hanger mounts
- Slide OEM muffler out and remove from 3″ inlet tube connection
NOTE: Read before install. Carven Exhaust Inc, recommends professional installation for all of our products. Install products at your own risk.
Overview
Allow exhaust system temperatures to cool down, 2-3 hours after vehicle has
been running is recommended. Refer to power tools and equipment manuals for
proper safety instructions.
safety wear is recommended, serious injuries and burns can occur if proper
safety precautions are not taken. If you have any questions please contact
info@carvenexhaust.com or
951-817-5101.
Carven Exhaust is not responsible for performance on install nor warranty.
Customer to verify due diligence regarding install and warranty.
Carven Exhaust is not responsible for performance on install nor warranty.
Customer to verify due diligence regarding install and warranty. For more
install instructions & tips please visit our YouTube channel @ Carven Exhaust.
Parts included
- 2.25″ band clamp QTY: 2
- 3″ band clamp QTY: 1
Installation
Step 1
- Reinstall rubber grommet on hanger mounts, then insert new exhaust into hangers. Slide 3″ clamp over inlet tube and line up with inlet tube on new exhaust
- Insert 3″ OEM tube into Carven kit, slide 3″ clamp to inlet. Once pieces are in position, tighten clamp snuggly
Step 2
- Slide the 2.25″ clamps over corresponding tubing and run all the way down to the hangers
- Insert tailpipe into kit, then align and slide 2.25″ clamp towards the tailpipe (do not slide clamp rivet on inlet)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>