GENERATION LIGHTING 7532002 Vander Flush Mount Instruction Manual
- June 13, 2024
- GENERATION LIGHTING
Table of Contents
Installation Instructions for
Vander Flush Mount
VANDER_FLUSH1.0
7532002
7532002 Vander Flush Mount
FLUSH MOUNT
GPENERAL RODUCT INFORMATION:
These fixtures are intended to be installed utilizing NEC compliant junction
boxes.
This product is safety listed for damp locations.
This instruction shows a typical installation.
CAUTION RISK OF FIRE
– This product must be installed in accordance with the applicable
installation code by a person familiar with the construction and operation of
the product and the hazards involved.
Use minimum 90°c supply conductors.
SAVE THESE INSTRUCTIONS!
Install the Fixture
- If necessary, screw the shorter end of the threaded nipple tightly onto the mounting plate.
- Secure the mounting plate to the junction box.
- Connect the fixture to a suitable ground in accordance with local electrical codes.
- Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
- Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
- Properly tuck the wires into the junction box, place the fixture base and washer onto the threaded nipple, and secure them in place by screwing the hex nut onto the threaded nipple. Screw the knurled nut onto the threaded nipple.
- Screw the lamp into the socket. Refer to the label on the socket for Max Wattage Information.
- Place the shade in the ring, then secure the ring to the fixture using by screwing the thumb nuts onto the threaded nipples.
©2023 Visual Comfort & Co., L.L.C. All rights reserved. The Visual Comfort &
Co. logo is a registered trademark of Visual Comfort & Co.
Visual Comfort & Co. reserves the right to change specifications for product
improvements without notification.
7400 Linder Ave., Skokie, IL 60077
T 847.410.4400 | F 847.410.4500
www.generationlighting.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>