SupaWarm SFH10 Deluxe Fan Heater Instruction Manual
- June 13, 2024
- SupaWarm
Table of Contents
- PARTS IDENTIFICATION
- ELECTRICAL SAFETY
- DISPOSAL
- IMPORTANT SAFETY INSTRUCTIONS
- WARNINGS
- USING YOUR HEATER
- USING YOUR HEATER
- OVERHEATING
- AUTO SAFETY SHUT OFF
- CARE, CLEANING AND STORAGE
- TECHNICAL DETAILS
- CORRECT DISPOSAL OF THIS PRODUCT
- THANK YOU FOR PURCHASING
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
SupaWarm SFH10 Deluxe Fan Heater
PARTS IDENTIFICATION
(A) Air Outlet Grille
(B) Thermostat Dial
(C) On/Off Indicator Light
(D) Heat Setting Dial
(E) Oscillating On/Off Switch
ELECTRICAL SAFETY
RATING
- AC 220-240V ~ 50Hz, 2200-2400W.
- Class of insulation: ll
- Ensure that the voltage indicated on the identification plate corresponds with the mains voltage.
Please read these instructions fully before use.
THE HEATER MUST BE POSITIONED UPRIGHT.
DISPOSAL
IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH EC DIRECTIVE 2002/96/EC
At the end of its working life, the product must not be disposed of asurban waste. It must be taken to a special local authority differentiated waste collection centre or to a dealer providing this service. Disposing of a household appliance separately avoids possible negative consequences for the environment and health, avoiding inappropriate disposal enables the constituent materials to be recovered to obtain significant savings in energy and resources. As a reminder of the need to dispose of household appliances separately, the product is marked with a crossed-out wheeled dustbin.
IMPORTANT SAFETY INSTRUCTIONS
PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE USING THE PRODUCT.
When using an electrical appliance, basic safety precautions should always be observed, as explained in this manual.
WARNING: To reduce the risk of fire, electrical shock, or injury to person or property:
-
Check that the mains voltage corresponds with the rating of the appliance.
-
Do NoT touch hot surfaces – Use handles or knobs.
-
To protect against electric shock, do not immerse cords, plugs or appliances in water or any other liquid. leave any appliance unattended while it is operating. Close supervision is necessary when any appliance is used by or near children or infirm persons.
Unplug from outlet when not in use or before cleaning. Allow to cool before putting on or taking off any parts. -
Do NoT operate the appliance with a damaged cord or plug, or after the appliance has been damaged in any manner.
-
If the supply cord or appliance is damaged, it must be replaced by the manufacturer or it,s service agent or a similarly qualified person, in order to avoid a hazard.
-
CAUTION! In order to avoid a hazard due to inadvertent resetting of the thermal cutout, this appliance must not be supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility.
-
The use of accessory attachments is not recommended by the appliance manufacturer, this may cause injuries.
-
Do NoT use outdoors.
-
DO NOT let the cord hang over the edge of a table or counter or let it come into contact with any hot surfaces.
-
To disconnect, remove the plug from the outlet. Do not pull plug out by the cord.
-
No liability can be accepted for any damage caused by noncompliance with these instructions or any other improper use or mishandling.
-
NEVER use the appliance near a bath, shower or a swimming pool.
-
NEVER place flammable objects or clothing on top of the heater.
-
Allow a 50cm safe area around the heater on the top and sides and a 120cm safe area at the front.
-
NEVER use a heater in a room with explosive gas such as petrol, or while using any kind of flammable glues, sprays or solvents.
-
Prevent overheating of the appliance by keeping the air inlets and outlets clean and free of anything that may cause blockage. Check all inlets and outlets from time to time for accumulated dust. DO NOT COVER!
-
lf overheating should occur, the built-in overheating safety device will shut the appliance off.
-
DO NOT insert any foreign objects into the grill.
-
Keep the rear grill clear of any draped fabric or curtains.
-
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
-
Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
-
Children of less than 3 years should be kept away unless continuously supervised.
-
Children aged from 3 years and less than 8 years shall only switch on/off the appliance, provided that it has been placed or installed in its intended operating position and they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
-
Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance.
-
CAUTION! Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present.
WARNINGS
- In order to avoid overheating, DO NOT COVER THE HEATER!
- Do not use this heater with a programmer, timer, separate remote-control system or any other device that switches the heater on automatically, since a fire risk exists if the heater is covered or positioned incorrectly.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
- Children should be supervised to ensure that they do not play with the appliance.
- Always use the heater on a flat level stable surface.
- The heater must not be located immediately below a socket-outlet.
USING YOUR HEATER
Controls
OFF
Fan Only, No Heat
I Low Heat Output
II Fu|| Heat Output
WARNING! PLEASE NOTE
There may be a small amount of smoke emitted as the element first heats and burns any residue left from manufacture, this will stop fairly quickly, but it is recommended that a window is briefly opened to vent smoke released when first used.
- Remove the heater from all packaging and place it in desired location.
- Ensure that there is a safe area between the heater and furniture, curtains, etc. 50cm safe area from top and sides and 120cm safe area in front.
- Unwind the power cord and plug it into the power outlet.
THERMOSTAT :
Turn clockwise to increase the heat output.
-
Plug the heater into a suitable power outlet, observing all the instruction regarding positioning, and switch on.
at room temperature. -
If the fan does not operate, the ambient room temperature is cooler than the built-in thermostat “OFF” level. Turn the thermostat dial gradually clockwise and the fan will start blowing.
USING YOUR HEATER
- As soon as the fan starts, the light in the front of the machine will illuminate.
- To distribute heat evenly around a room, press oscillating switch.
To use the machine for heating:
- Turn the control dial to “l” for low heat and “II” for full heat.
- Set the level of heat by turning the thermostat dial gradually clockwise for the lowest heat and fully clockwise for maximum.
- The thermostat will turn the machine off when the selected room heating is achieved, and when the temperature drops it will turn on again automatically.
- For maximum heat output use “II” with the thermostat turned fully clockwise.
Safety Tip-Over Switch
The appliance is fitted with a tip-over switch. When you use the appliance in an upright position on a flat and stable surface, the tip-over switch will be on. In the event the heater is knocked over, the heater will stop functioning automatically.
OVERHEATING
- The thermostat will turn the machine off it overheats.
- Overheating can be caused by obstruction to the air intakes on the back of the machine or the grill on the front. If this occurs please disconnect the machine and allow it to cool for 30 minutes. Remove any obstruction and turn the machine back on.
- If the heater ceases to function, the most likely cause is a blown fuse. Simply replace the 13amp fuse in the plug and reconnect. If the heater still ceases to function, please unplug it, do not use it and contact the repair centre.
AUTO SAFETY SHUT OFF
The heater has a built-in safety device, which will switch the heater OFF in case of accidental overheating. To reset the heater, follow the next steps:
- Turn the control setting to the ‘O, position.
- Unplug the heater and wait 5 -10 minutes for the unit to cool down.
- After the unit has cooled, plug it in and operate normally.
- Turn settings switch into desired position (fan, low or high).
- Turn the thermostat switch to the desired temperature position.
- When you feel the room temperature is comfortable, turn
- the thermostat switch anti-clockwise slowly to the minimal direction until the appliance switches off. The thermostat switch will keep the room temperature at the desired temperature automatically.
- You can also turn the thermostat switch anti-clockwise to the minimum position or turn the thermostat switch clockwise to the maximum position to make the temperature lower or higher.
Please Note: NEVER COVER THE HEATER
CARE, CLEANING AND STORAGE
There are no parts inside the machine that require your attention or servicing. Do not try to open the outer case. By doing so you could damage the motor and heating element and invalidate the warranty. If you have a problem with the heater, or if the power cord gets damaged in any way you MUST take the unit to a suitably qualified engineer or electrical repair centre
- Before cleaning the machine, please make sure it is
- disconnected from the power supply and has cooled down completely.
- Do not clean the machine in water and do not let it get wet under any circumstances.
- The outer casing can be cleaned using a slightly damp lint-free cloth (a small amount of detergent can be used if required).
- To remove any dust from inside the front grille,or the rear air intakes, you can use a regular vacuum cleaner.
- Always make sure the machine is completely dry before using.
- If you are not going to use the heater for a while, it is best to make sure that it is clean and dry and then store it inside a plastic bag in a cool dry place.
- With sensible care and attention, this heater will give you many years of good service and economical heating.
TECHNICAL DETAILS
Model No: SFH10
Table: Model Identifier for Electric Local Space Heaters
Item| Symbol| Value| Unit
Heat Output
Nominal heat output| Pnom| 2.2-2.4| kW
Minimum heat output (indicative)| Pmin| 0.0,8| kW
Maximum continuous heat output| Pmax, c| 2.4| kW
Auxiliary Electricity Consumption
At nominal heat output| elmax| 0| kW
At minimum heat output| elmin| 0| kW
In standby mode| elss| 0| kW
Type of heat input, for electric storage local space heaters only (single
select)
Manual heat charge control, with integrated thermostat| □ Yes ✖ No
---|---
Manual heat charge control, with room and/or outdoor temperature feedback| □
Yes ✖ No
Electronic heat charge control with room and/or outdoor temperature feedback|
□ Yes ✖ No
Fan assisted heat output| □ Yes ✖ No
Type of heat output/room temperature control (single select)
Single stage heat output and no room temperature control| □ Yes ✖ No
Two or more manual stages, no room temperature control| □ Yes ✖ No
With mechanic thermostat room temperature control| Yes□ ✖No
With electronic room temperature control| □ Yes ✖ N o
Electronic room temperature control plus day timer| □ Yes✖ No
Electronic room temperature control plus week timer| □ Yes ✖ No
Other control options (multiple selections possible)
Room temperature control, with presence detection| □ Yes ✖ No
Room temperature control, with open window detection| □ Yes ✖ No
With distance control option| □ Yes ✖ No
With adaptive start control| □ Yes ✖ No
With working time limitation| □ Yes✖ No
With black bulb sensor| □ Yes✖ No
Contact Details| PO Box 1042, Ipswich, IP1 9XY
CONFORMITY WITH DIRECTIVES
MUNRO IMPORTERS LTD Declaration of Conformity
In accordance with Government Guidance
We, the importer:
Munro Importers Ltd
First Floor, Unit 1 The Quadrangle The Dri?, Nacton Road,
Ipswich Suffolk IP3 9QR
Declare that the product:
We, the importer:
Munro Importers Ltd
First Floor, Unit 1 The Quadrangle The Dri?, Nacton Road,
Ipswich Suffolk IP3 9QR
Declare that the product:
Product code: 732941 SFH10
Product description: SupaWarm 2400w Deluxe Fan Heater
Is in conformity with the relevant statutory instruments and their amendments:
Electromagnetic Compatibility Regulations 2016 and EMC Directive 2014/30/EU
Electrical Equipment (Safety) Regulations 2016 and Low Voltage Directive
2014/35/EU
COMMISSION REGULATION (EU) 2015/1188 of 28 April 2015 implementing Directive
2009/125/EC of the European Parliament and of the Council with regard to
ecodesign requirements for local space heaters
Directive 2011/65/EU on the Restriction of the Use of Certain Hazardous
Substances in Electrical and Electronic Equipment (RoHS) with its Amendments
(EU) 2015/863
And is manufactured in accordance with the following Standard or standardized documents:
EMC
EN 55014-1:2017+A11, EN 55014-2:2015, EN 61000-3-3:2013+A1, EN IEC
61000-3-2:2019
BS EN 60335-2-30:2009+A11, BS EN 60335-1:2012+A11+A13+A1+A14+A2, BS EN
62233:2008, AfPS GS 2019:01 PAK
EN 62321-1:2013, EN 62321-2:2014, EN 62321-3-1:2014, EN 62321-4:2014/A1:2017,
EN 62321-5:2014, EN 62321-7-1:2015,
EN 62321-7-2:2017, EN 62321-6:2015, EN 62321-8:2017
All documentation is held on file and is available, on request, for review. Authorized Signatory
Date: 16.05.2023
Name: Dominic Richardson
Position: Product Coordinator
Year of Manufacture: 2023
CORRECT DISPOSAL OF THIS PRODUCT
This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmental safe recycling.
THANK YOU FOR PURCHASING
For a complete range of fires, radiators and heaters please call or visit Supa
Brands for further information:
Website: www.supabrands.co.uk
Part of the extensive Supa Brand Range
Helpline: 01473 237 997
PO Box 1042, Ipswich, IP1 9XY
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>