fontastic XORA10C USB Solar Power Bank User Manual
- June 13, 2024
- fontastic
Table of Contents
fontastic XORA10C USB Solar Power Bank User Manual
Please read this user manual and follow the listed safety instructions and tips. Keep this manual so that you can access it at any time.
Scope of delivery
- Fontastic® Powerbank XORA10C
- USB charge cable
- This user manual
Function overview
- USB Type-C® input
- USB-A output
- Micro USB input
- Protective cover
- Battery level LED
- Solar LED
- Solar panel
- Power button
- Micro USB connector
- Type-C® connector
- 8-pin connector
- LED light
Charge power bank
The Fontastic® Powerbank XORA10C is equipped with a rechargeable lithium
polymer battery. Connect the powerbank to a USB charger via the micro USB or
Type-C input (3,1). The battery level indicator (5) flashes during charging.
When fully charged, all four LEDs light up. The charging process is finished.
Disconnect the power bank from the charger.
Note: Charge the power bank completely before using it for the first time. The usual charging time is approximately 4 hours, but may vary depending on the power of the USB charger used.
Solar panel:
The powerbank is equipped with a solar module (7), which charges the powerbank
as soon as the light conditions are sufficient. The green LED (6) lights up
when the powerbank is currently charging via the panel.
Note: The solar panel is primarily intended for emergency use. If possible, charge the powerbank from the mains.
Check battery level of the power bank
To check the battery level, press the power button (8).
The LED indicator (5) will light up for a few seconds, showing the powerbank‘s
battery level in 25% increments. 100% means that your powerbank is fully
charged, 25% means that it is almost empty and should be charged promptly.
Charge devices using the power bank
To charge devices using the powerbank, remove the cable with the appropriate
plug for your device from the case (9, 10, 11) and connect it to the device
you want to charge. The charging process will begin. Disconnect the cable from
the device to be charged after use.
In addition to the integrated cables, a USB-A port (2) is available for
charging external devices.
Open the protective cover (4) to access the ports of the power bank. Connect the device to be charged to a USB cable, and this to the USB-A output of the power bank. The charging process will begin. Disconnect the cable from the powerbank after use.
Note: If a short circuit occurs while charging a device, the powerbank will shut down. Plug the cable into the Micro-USB or Type-C input of the powerbank, and connect the USB-A plug of the cable to a USB charger or a computer. A short charging pulse is enough to reactivate the powerbank.
LED Light:
The integrated LED light (12) is operated by the power button (8). To switch
on and off, press and hold the power button for approx. 3 seconds.
If you need technical support, please contact our support team by email at service@fontastic.eu.
Technical data
- Battery: 10,000 mAh Li-Polymer
- Micro USB/Type-C input: DC 5V/2.0A
- Charging power solar panel: Max. 1.2W
- Output USB-A: DC 5V/2A
- Output cable with Micro USB/8-pin/Type-C: DC5V / 2.0A
- LED charge level indicator
- Protection against: short circuit, overcharge, discharge, overcurrent.
- Material case: ABS + silicone
- Dimensions: 168 x 77 x 22 mm
- Weight: 310g
Safety advice
- Do not open the device.
- Do not hold the device under water.
- Keep it safe from humidity.
- Do not connect the power output to the power input or vice versa.
- Do not connect the adapter to the device by using force.
- Keep the device away from children.
- Disconnect electronic devices from the power when not using them for longer time.
- Do not use the device when it has visible defects.
Note on environmental protection
After the implementation of the European Directive 2012/19/EU in the national
legal system, the following applies: Electrical and electronic devices may not
be disposed of with domestic waste. Consumers are obliged by law to return
electrical and electronic devices at the end of their service lives to the
public collecting points set up for this purpose or point of sale. Details to
this are defined by the national law of the respective country.
This symbol on the product, the instruction manual or the package indicates
that a product is subject to these regulations. By recycling, reusing the
materials or other forms of utilising old devices, you are making an important
contribution to protecting our environment.
We hereby declare, that this device carries the CE mark in accordance with the regulations and standards.
It therefore complies with the essential requirements of the EMC Directive 2014/30/EU, as well as the Low Voltage Directive 2014/35/EU and the RoHS Directive 2011/65/EU. The full text of the EU Declaration of Conformity is available at the following Internet address: www.d-parts.de/konfo
Technische Daten und Irrtümer vorbehalten / Technical data and errors excepted
USB Type-C® and USB-C® are registered trademarks of USB Implementers Forum.
Registered trademarks are the property of their respective owners.
Fontastic, by D-Parts GmbH
Birkenweiher Str. 16
63505 Langenselbold, Germany, www.d-parts.de
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>