TOOLCRAFT 2859419 LED Torch and Power Bank Instruction Manual

TOOLCRAFT 2859419 LED Torch and Power Bank

Product Information

Product Usage Instructions

• Intended Use
  The product is a rechargeable battery-operated torch light with a power bank function.

• Important:
  Risk of permanent eye damage and blindness! Never shine the light directly into your eyes.

• Safety Instructions
  Read the operating instructions carefully and especially observe the safety information. If you do not follow the safety instructions and information on proper handling, we assume no liability for any resulting personal injury or damage to property. Such cases will invalidate the warranty/guarantee.

• Latest Product Information
  Download the latest product information at www.conrad.com/downloads or scan the QR code shown. Follow the instructions on the website.

• Operating Instructions
  Read the operating instructions carefully and store them in a safe place. Make this product available to third parties only together with the operating instructions.

Technical Specifications

LED Torch and Power Bank

• Item no: 2859419 (8,000 lm, 5000 mAh)
• Item no: 2859420 (10,000 lm, 5000 mAh)

Intended use
The product is a rechargeable battery-operated torch light with a power bank function.

Important:
Risk of permanent eye damage and blindness! Never shine the light directly into your eyes.

Notes:

• The product has an IPX6 ingress protection rating and is protected against jets of water from all directions. Do not submerge.
• All port and battery covers must be properly sealed for effective protection against ingress.

1. If you use the product for purposes other than those described, the product may be damaged.
2. Improper use can result in short circuits, fires, or other hazards.
3. The product complies with the statutory national and European requirements.
4. For safety and approval purposes, you must not rebuild and/or modify the product.
5. Read the operating instructions carefully and store them in a safe place. Make this product available to third parties only together with the operating instructions.
6. All company names and product names are trademarks of their respective owners. All rights reserved.
7. USB4®, USB Type-C®, and USB-C® are registered trademarks of USB Implementers Forum.

Delivery contents

• Product
• USB-A to USB-C® charging cable
• Operating instructions

Latest product information

Download the latest product information at www.conrad.com/downloads or scan the QR code shown. Follow the instructions on the website.

Description of symbols

The following symbols are on the product/appliance or are used in the text:

• The symbol warns of hazards that can lead to personal injury.
• The symbol warns of hot surfaces that can result in burns when touched. Use a handhold grip. Do not hold by head/lens.
• Possibly hazardous optical radiation is emitted from this product. Do not stare at the operating lamp. May be harmful to the eyes.
• This product is constructed according to protection class III.

**Safety instructions

**

Read the operating instructions carefully and especially observe the safety information. If you do not follow the safety instructions and information on proper handling, we assume no liability for any resulting personal injury or damage to property. Such cases will invalidate the warranty/guarantee.

General

• The product is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. This may become dangerous playing material for children.
• If you have questions that remain unanswered by this information product, contact our technical support service or other technical personnel.
• Maintenance, modifications, and repairs must only be completed by a technician or an authorized repair center.

Handling
Handle the product carefully. Jolts, impacts or a fall even from a low height can damage the product.

Operating environment

• Do not place the product under any mechanical stress.
• Protect the appliance from extreme temperatures, strong jolts, flammable gases, steam, and solvents.
• Protect the product from direct sunlight.

Operation

• Consult an expert when in doubt about the operation, safety, or connection of the product.
• If it is no longer possible to operate the product safely, take it out of operation and protect it from any accidental use. DO NOT attempt to repair the product yourself. Safe op-eration can no longer be guaranteed if the product:
  • is visibly damaged,
  • is no longer working properly,
  • has been stored for extended periods in poor ambient conditions or
  • has been subjected to serious transport-related stresses.

Li-ion battery

• Never damage the rechargeable battery. Damaging the casing of the rechargeable battery might cause an explosion or a fire!
• Never short-circuit the contacts of the rechargeable battery. Do not throw the battery or the product into fire. There is a danger of fire and explosion!
• Charge the rechargeable battery regularly, even if you do are not using the product. Due to the rechargeable battery technology being used, you do not need to discharge the re-chargeable battery first.
• Never leave the rechargeable battery of the product unattended.
• When charging, place the product on a surface that is not heat-sensitive. It is normal that a certain amount of heat is generated during charging.

LED light

Important:
Risk of permanent eye damage and blindness! Never shine the light directly into your eyes.

• Do not look directly into the LED light!
• Do not look into the beam directly or with optical instruments!

Connected devices

• Also, observe the safety and operating instructions of any other devices which are connected to the product.

Photosensitive epilepsy
People suffering from photosensitive epilepsy are susceptible to seizures or loss of consciousness if exposed to flashing lights or light patterns.

Product Overview

• Item No.: 2859419 is shown below.

1. Lanyard hole
2. Battery compartment cover
3. Handle
4. Mode button
5. Beam focus slider
6. Lens

Battery

Note:
Remove the plastic battery insulation strip when using it for the first time.

Recharge the battery

Preconditions:
The power is switched OFF.

1. Open the USB cover to access the charging port.
2. Connect one end of the charging cable to the charging USB-C© input.
3. Connect the other end of the charging cable to a suitable power supply.
4. Close the USB cover when charging is complete. Make sure it is properly sealed.

Replace the battery

1. Unscrew then remove the battery cover.
2. Insert a battery matching the polarity shown inside.
3. Replace the battery compartment cover. Make sure the seal around the battery compartment cover is seated properly.

Operation

Preconditions:

Light brightness adjust
Press the function button repeatedly to toggle through modes: high →medium → low → OFF.

Strobe/SOS

Preconditions:
The light is switched OFF.

1. Press and hold the function button to switch the strobe ON.
2. Short press the function button to switch the strobe OFF.

Powerbank

Preconditions:
You have a suitable charging cable.

1. Open the USB cover to access the charging output.
2. Connect one end of the charging cable to the USB-A charger output.
3. Connect the other end of the charging cable to a mobile device.
   • Charging begins automatically upon connection.
4. Close the USB cover when charging is complete. Make sure it is properly sealed.

Status indicator lights

Cleaning

Important:

• Do not use aggressive cleaning agents, rubbing alcohol or other chemical solutions. They damage the housing and can cause the product to malfunction.
• Do not immerse the product in water.

1. Switch the product off.
2. Let the product cool down to ambient temperature.
3. Clean the product with a dry, fibre-free cloth.

Disposal

Product
This symbol must appear on any electrical and electronic equipment placed on the EU market. This symbol indicates that this device should not be disposed of as unsorted municipal waste at the end of its service life. Owners of WEEE (Waste from Electrical and Electronic Equipment) shall dispose of it separately from unsorted municipal waste. Spent batteries and accumulators, which are not enclosed by the WEEE, as well as lamps that can be removed from the WEEE in a non-destructive manner, must be removed by end users from the WEEE in a non-destructive manner before it is handed over to a collection point.

Distributors of electrical and electronic equipment are legally obliged to provide free take-back of waste. Conrad provides the following return options free of charge (more details on our website):

• in our Conrad offices
• at the Conrad collection points
• at the collection points of public waste management authorities or the collection points set up by manufacturers or distributors within the meaning of the ElektroG

End users are responsible for deleting personal data from the WEEE to be disposed of. It should be noted that different obligations about the return or recycling of WEEE may apply in countries outside of Germany.

(Rechargeable) batteries
Remove batteries/rechargeable batteries, if any, and dispose of them separately from the product. According to the Battery Directive, end users are legally obliged to return all spent batteries/rechargeable batteries; they must not be disposed of in the normal household waste.

• Batteries/rechargeable batteries containing hazardous substances are labeled with this symbol to indicate that disposal of household waste is forbidden. The abbreviations for heavy metals in batteries are:
  • Cd = Cadmium, Hg = Mercury,
  • Pb = Lead (name on (rechargeable) batteries, e.g. below the trash icon on the left).

Used (rechargeable) batteries can be returned to collection points in your municipality, our stores, or wherever (rechargeable) batteries are sold. You thus fulfill your statutory obligations and contribute to environmental protection. Batteries/rechargeable batteries that are disposed of should be protected against short circuits and their exposed terminals should be covered completely with insulating tape before disposal. Even empty batteries/rechargeable batteries can contain residual energy that may cause them to swell, burst, catch fire, or explode in the event of a short circuit.

Technical data

Item No.: 2859419

• Input (USB-C®) ………………………… 5 V/DC, max. 2 A
• Output (USB-A) ………………………… 5 V/DC, 1 A
• Rechargeable batteries ……………… 7.4 V 37 Wh 5000 mAh 2x 26650 Li-ion
• Battery recharge time ………………… 10 – 12 hrs
• Battery life………………………………… High (3 hrs), Med (4 hrs 45 mins.), Low (10 hrs)
• Housing material……………………….. air-craft grade aluminum
• Ingress protection……………………… IPX6
• Protection class ………………………… III
• Color temperature……………………. 6000 -7000 K
• LED…………………………………………. Type: COB, lifespan: 30,000 hrs
• Protection mechanism……………….. over-discharge, over-charge, short-circuit
• Light modes……………………………… High / Middle / Low / OFF Strobe
• Lumens……………………………………. High (8000 lm), Med (4000 lm), Low (540 lm)
• Irradiation distance ……………………. max. 236 m
• Operating/storage conditions…….. -20 to +60 °C
• Dimensions (ø x H)……………………. 62.6 x 276.5 mm
• Weight …………………………………….. 730 g (including batteries)

Item No.: 2859420

• Input (USB-C®) ………………………… 5 V/DC, max. 2 A
• Output (USB-A) ………………………… 5 V/DC, 1 A
• Rechargeable batteries ……………… 7.4 V 37 Wh 5000 mAh 2x 26650 Li-ion
• Battery recharge time ………………… 10 – 12 hrs
• Battery life………………………………… High (1 hr 45 mins.), Med (4 hrs), Low (10 hrs)
• Housing material……………………….. air-craft grade aluminum
• Ingress protection……………………… IPX6
• Protection class ………………………… III
• Color temperature……………………. 6000 – 7000 K
• LED…………………………………………. Type: COB, lifespan: 30,000 hrs
• Protection mechanism……………….. over-discharge, over-charge, short-circuit
• Light modes……………………………… High / Middle / Low / OFF Strobe
• Lumens……………………………………. High (10000 lm), Med (3900 lm), Low (580 lm)
• Irradiation distance ……………………. max. 237 m
• Operating/storage conditions…….. -20 to +60 °C
• Dimensions (ø x H)……………………. 62.6 x 276.5 mm
• Weight …………………………………….. 730 g (including batteries)

This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com). All rights including translation reserved. Reproduction by any method (e.g. photocopying, microfilming or the capture in electronic data processing systems) requires prior written approval from the editor. Reprinting, also in part, is prohibited. This publication reflects the technical status at the time of printing.

Copyright by Conrad Electronic SE.
2859419, 2859420_V2_0723_dh_mh_en 9007200186857483-2 I2/O2 en.

References

• Conrad Electronic » All parts of success
• Conrad Electronic » All parts of success
• Download center

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>