ZAAOEHA 36 Extra Tall Baby Gate Stairs Doorways Instruction Manual

ZAAOEHA 36 Extra Tall Baby Gate Stairs Doorways Instruction Manual

Warning:

• Read all instructions before assembling and using the gate.
• Do not cut off the strap before installation is complete. The door gap is not a defect; it will adjust to an appropriate distance as you install the gate.
• Keep these instructions for future reference.

COMPONENT

A Gate door x 1
B Extension x 3
C Reinforcement Slot x 3
D Tension Bolt x 4
E Wall Cup x 4
F Screw x 4
G Dry Wall Anchor x4
H Wrench x 1

HARDWARE

SPECIAL REMINDER

You have the flexibility to choose between two installation methods, either for pressure-mounted or hardware-mounted options.

• METHOD A
  Pressure Mounted

• METHOD B
  Hardware Mounted
  

NOTICE: If you intend to use the gate at the top of stairs, please follow method B.

METHOD A

Pressure Mounted Installation

STEP 1: Measure the width

STEP 2: Determine Your Size

Based on the measured opening size, select the appropriate extension.

STEP 3: Install Accessories C & D

Insert 4 bolts into 4 corners of the gate/extension

Add the reinforcement slot at the bottom

Notice:
The bottom of the gate frame must be CLOSE to the floor, do not hang on the ground

STEP 4: Complete the installation

1. Rotate both bottom tension bolts simultaneously, then do the same with the top tension bolts.
   

2. Pay attention to adjust the left and right clearances for consistent alignment.
   

STEP 5: Cut off the strap and test the gate

1. Push the gate to test its stability.
   

2. Rotate the base lock to a horizontal position to allow the door to swing open.
   

3. 0pen and close the gate.
   

METHODB

Hardware Mounted Installation

STEP1: Pre-assemble the gate.

Mark the locations of the tension bolts. Remove the gate, position the wall cup, and mark the center holes.

STEP 2: Drill holes

Drill holes at the four marked positions, insert drywall anchors, and then attach wall cups to the wall using screws.

STEP 3: Install the gate

Continue with Steps 2 to 5 from Pressure Mounted Installation.

TROUBLE SHOOTING

1. Gate is not properly aligned onto the door frame and floor.
   Solution: Loosen all tension bolts and reposition the gate. Align it properly onto the door frame/wall and floor, then retighten the tension bolts.

2. The gate is over-tightened or not tight enough.
   Solution: Adjust the tension bolts on each side until the gate is centered and level, with equal distance between the gate and the wall on both sides, top and bottom.

3. Cut strap by accident or need to reinstall the gate elsewhere in the future.
   Solution: Use another rope/belt to secure the gate. Otherwise, seek assistance during reinstallation.

WARNING

• To prevent serious injury or death, securely install and use the gate according to the manufacturer’s instructions.
• Never use with a child who can climb over or dislodge the gate.
• This product will not prevent all accidents.
• Never leave a child unattended.
• Only use when the locking mechanism is securely engaged.
• Intended for use with children from 6 to 24 months of age.
• Discontinue use if any parts are missing or damaged.
• Regularly check all fasteners to ensure they are secure.
• Adult assembly required.
• The surfaces the gate is attached to must be suitable and structurally sound.
• For indoor use only; do not expose to outdoor elements.
• Install away from heaters and other sources of heat.
• Children have died or been seriously injured due to improperly installed gates.
• Always follow instructions and use all required parts.
• Never use to keep a child away from a pool.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>