Schreder OWLET IV NEMA NAM Luminaire Controllers Instruction Manual
- June 13, 2024
- Schreder
Table of Contents
OWLET IV NEMA NAM Luminaire Controllers
Instruction Manual
PRODUCT
DATALIFT N
Ta: -40°C to +65°C -40°F to +149°F
Mains voltage: 110-277V
Frequency: 50/60Hz
Max load current: 7.5A
MESHNODE N
Ta: -40°C to +65°C -40°F to +149°F
Mains voltage: 110-277V
Frequency: 50/60Hz
Max load current: 7.5A
BEST LOCATION, RATIO & DISTANCE
INSTALLATION
-
Before installation contact Schrader FAE (Field Application Engineer) for support.
-
During installation, ensure correct body position over the luminaire.
-
Turning indications on top of controller. Hold controller.
-
Align the controller power pins with slots in the socket.
Align the longer pin (Neutral) first.
-
Check if the surfaces between the controller and NEMA socket are parallel and plug in.
-
Push the controller firmly down. Make sure it is vertically aligned.
-
Turn controller ± 45° clockwise until it locks.
VERIFICATION The installer is responsible for verifying the installation. -
Visual Verification
Correct installation: Surfaces of controller and NEMA socket are parallel. Incorrect installation: Surfaces of controller and NEMA socket are twisted. NEMA socket with internal RFID Symbol on controller and gasket are aligned. -
Mechanical Verification
Pull the controller up to check if it is locked
NEMA socket with external RFID Symbol on
controller and socket label are aligned.
-
Extra barcode labels are supplied with the controller
SELF-TEST
Note: the self-test occurs only in the first 5 power cycles after
installing the controller.
When powering on luminaire, the light switches ON to maximum level.
The controller reduces light to minimum level. The
controller switches OFF the light completely.
30 seconds
Correct Luminaire is ON Incorrect Luminaire is OFF Built-in LED controller
is ON
OPTIONAL SENSOR TEST trigger a sensor dectection in the luminaire
Correct: Light level changes from max to min
Incorrect: Light level does not change 120 minutes
After the self-test, the luminaire operates as configured on the CMS
platform.
Certification
FCC Regulatory Notices: DATALIFT N NAM
FCC ID: 2AW4F-OW4NDNAM
Contains FCC ID: QOQMGM13P
Contains FCC ID: XMR201909EG91NAX
No changes shall be made to the device without the manufacturer’s permission
as this may void the user’s authority to operate the device.
The DATALIFT N NAM complies with FCC RF radiation exposure limits set forth
for an uncontrolled environment.
The DATALIFT N NAM complies with the safety requirements for RF exposure for
mobile (>20 cm) use conditions in accordance with FCC rule part 2.1091.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
MESHNODE N NAM
FCC ID: 2AW4F-OW4NMNAM
Contains FCC ID: QOQMGM13P
No changes shall be made to the device without the manufacturer’s permission
as this may void the user’s authority to operate the device.
The MESHNODE N NAM complies with FCC RF radiation exposure limits set forth
for an uncontrolled environment.
The MESHNODE N NAM complies with the safety requirements for RF exposure for
mobile (>20 cm) use conditions in accordance with FCC rule part 2.1091.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
ISED Canada Regulatory Notices:
DATALIFT N NAM
IC:26343-OW4NDNAM
Contains IC: 5123A-MGM13P
Contains IC: 10224A-2019EG91NAX (for the Data Lift)
MESHNODE N NAM
IC:26343-OW4NMNAM
Contains IC: 5123A-MGM13P (for the Mesh Node)
This device is compliant with ISED Canada license-exempt RSS standards.
Operation is authorised under the following two conditions:
- the device may not cause harmful interference;
- the device must accept any interference received, even if it compromises operation.
This equipment complies with ISED Canada RSS-102 radiation exposure limits set forth for the general population. This equipment complies with the safety requirements for RF exposure in accordance with RSS-102 Issue 5 section 2.5.2 for mobile (>20 cm) use conditions. The minimum compliance distance is 20 cm.
DOC-0023004 OWLET IV NEMA NAM-INS-B | 09-2023
www.schreder.com
QR code to
access the online installation instruction.
https://library.schreder.com/view/535718717/
Documents / Resources
|
Schreder OWLET IV NEMA NAM Luminaire
Controllers
[pdf] Instruction Manual
OWLET IV NEMA NAM Luminaire Controllers, OWLET IV, NEMA NAM Luminaire
Controllers, Luminaire Controllers, Controllers
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>