FRONT RUNNER KVXSUNNI Wind Fairing for Low Profile Rack Instruction Manual

SLIMPRO VAN RACK EXPEDITION RAILS
KVXSUNNI
START HERE!
READ ME FIRST

Don’t be a hero and muscle through this installation without reading these fitting instructions first! Improper installation of this gear may void certain aspects of your warranty.
Before you begin, take a moment and open all your Front Runner Rack Kit boxes and gather the assembly instructions for the various components.

A complete kit will contain:

1. Front Runner Mounting System specific to your vehicle
2. Front Runner Rack Tray or Load Bar Slats

This document will guide you through the assembly of the Mounting System and assist you in fitting the Rack tray or Load Bars to your specific vehicle.
Please refer to the next page for a list of all the components, quantities and tools required.

IMPORTANT WARNING!
IT IS CRITICAL THAT ALL FRONT RUNNER PRODUCTS BE PROPERLY AND SECURELY ASSEMBLED AND ATTACHED TO YOUR VEHICLE. IMPROPER ATTACHMENT COULD RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY INJURY OR DEATH. YOU ARE RESPONSIBLE FOR ASSEMBLING AND SECURING ALL FRONT RUNNER PRODUCTS TO YOUR VEHICLE, CHECKING THE ATTACHMENTS PRIOR TO USE, AND PERIODICALLY INSPECTING THE PRODUCTS FOR ADJUSTMENT, WEAR AND DAMAGE. THEREFORE, YOU MUST READ AND UNDERSTAND ALL OF THE INSTRUCTIONS AND PRECAUTIONS SUPPLIED WITH YOUR FRONT RUNNER PRODUCT PRIOR TO INSTALLATION OR USE. IF YOU DO NOT UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS, OR IF YOU HAVE NO MECHANICAL EXPERIENCE AND ARE NOT THOROUGHLY FAMILIAR WITH THE INSTALLATION PROCEDURES, YOU SHOULD HAVE THE PRODUCT INSTALLED BY A PROFESSIONAL INSTALLER OR OTHER QUALIFIED PERSONNEL.
NOTE: Front Runner will not be responsible for any damage caused by the failure to install the product according to these instructions.
Please call us if you have any questions about the installation of this product.

**** CHECK ONLINE FOR THE LATEST FITMENT GUIDE
WWW.FRONTRUNNEROUTFITTERS.COM

GET ORGANIZED

IN THE BOX

TOOLS NEEDED

Diagram for illustration
purposes only

FIGURE 1.1

| 1
2
4
7| 2 X
3 X
1 X
1 X| LH / RH Drop Set
Expedition Rail Joiner
Rail Tubing (460mm)
Expedition Rail Fastner kit
  KVXS007| #| QTY| IN THE BOX
---|---|---|---
| 1
2
5
7| 2 X
3 X
1 X
1 X| LH / RH Drop Set
Expedition Rail Joiner
Rail Tubing (503mm)
Expedition Rail Fastner kit
  KVXS008| #| QTY| IN THE BOX
---|---|---|---
| 1
2
3
7| 1 X
4 X
1 X
1 X| LH / RH Drop Set
Expedition Rail Joiner
Rail Tubing (435mm)
Expedition Rail Fastner kit
 KVXS009| #| QTY| IN THE BOX
---|---|---|---
| 1
2
6
7| 1 X
3 X
2 X
1 X| LH / RH Drop Set
Expedition Rail Joiner
Rail Tubing (700mm)
Expedition Rail Fastner kit
  KVXS010| #| QTY| IN THE BOX
---|---|---|---
| 1
2
4
6
7| 2 X
5 X
1 X
1 X
1 X| LH / RH Drop Set
Expedition Rail Joiner
Rail Tube (460mm)
Rail Tube (700mm)
Expedition Rail Fastner kit
  KVXS011| #| QTY| IN THE BOX
---|---|---|---
| 1
2
5
7| 2 X
6 X
2 X
1 X| LH / RH Drop Set
Expedition Rail Joiner
Tube (503mm)
Expedition Rail Fastner kit

FIT AND SECURE

1. Determine where you want to mount your Expedition Rail Kit, Keep in mind that you migh have to remove some slats and rearrange the slats and Expedtion Rail Feet to fit the Expedition Rail Kit.
   

2. Remove the end cap and pre-assemble Items 1 and 7 before sliding the assembly into the side profile.
   

3. Adjust Items 3,4,5,6 so that it fits on items 1 and 2.
   After all the parts have been adjusted correctly, tighten all the fastners, and make sure it is secured.
   

KVXSUNNI_REV_A00
© 2022 FRONT RUNNER VEHICLE OUTFITTERS

Documents / Resources

| FRONT RUNNER KVXSUNNI Wind Fairing for Low Profile Rack [pdf] Instruction Manual
1345mm, 1425mm, KVXSUNNI, KVXSUNNI Wind Fairing for Low Profile Rack, Wind Fairing for Low Profile Rack, Fairing for Low Profile Rack, Low Profile Rack, Profile Rack, Rack
---|---

References

• FRONTRUNNEROUTFITTERS.COM

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>