GEORGE KOVACS P5951-077 5 in. 1-Light Wall Sconce User Manual

GEORGE KOVACS P5951-077 5 in. 1-Light Wall Sconce

Product Information

This product is Model # P5951-077, a fixture designed for installation in residential or commercial spaces. It is a lighting fixture that requires electrical wiring and is intended to be mounted on an outlet box. The fixture is compatible with 1*60w G9 Xenon Light Bulbs.

Product Usage Instructions

1. Before starting the installation process, make sure to shut off the power at the circuit breaker and remove any existing fixtures and mounting hardware.
2. Take out all the parts of the new fixture and lay them out in a clear area. Be careful not to lose any small parts that are necessary for installation.
3. Secure the Mounting Bracket (A) to the Outlet Box using Screws (B). Ensure that the side of the Mounting Bracket marked with GND and two convex points is facing outward.
4. Pass all the electrical wires through the Mounting Bracket.
5. Connect the electrical wires as shown in Fig. 1. Make sure to secure all wire connectors (C). If your outlet has a ground wire (green or bare copper), connect the fixture’s Ground Wire to it. Otherwise, connect the fixture’s Ground Wire directly to the Mounting Bracket or Reinforcement Plate using the Green Screw provided.
6. Fasten the fixture body onto the mounting bracket using screws (D).
7. Install 1*60w G9 Xenon Light Bulbs according to the lamp’s specifications. Make sure not to exceed the maximum wattage rating.
8. Slide the glass (E) into the slots on each side of the fixture body.
9. Important: It is recommended to have a qualified electrician install the fixture to ensure proper wiring and installation.
10. Caution: To avoid burns, wait for the fixture to cool down before replacing the light bulbs.

INSTALLATION INSTRUCTIONS

READ AND SAVE THESE INSTRUCTIONS

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

• Risk of shock, do not supply power to fixture before assembly is complete.
• Do not exceed the maximum wattage rating

MOUNTING INSTRUCTIONS

1. Shut off power at the circuit breaker and remove the old fixture and Mounting Hardware.

2. Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation.

3. Secure Mounting Bracket (A) using Screws (B) to the Outlet Box. The side of the Mounting Bracket with “GND” marked on it and two convex points must face out.

4. Pass all the electrical wires through the Mounting bracket.
   CONNECTING THE WIRES (Fig. 1)

5. Connect the electrical wires as shown in Fig. 1, making sure that all wire connectors (C) are secured. If your outlet has a ground wire (green or bare copper), connect the fixture’s Ground Wire to it. Otherwise, connect the fixture’s Ground Wire directly to the Mounting Bracket or Reinforcement Plate using the Green Screw provided.
   FINISHING THE INSTALLATION

6. Fasten the fixture body onto mounting bracket (A) using screws (D).

7. Install 1*60w G9 Xenon Light Bulbs in accordance with the lamp’s specifications. (DO NOT EXCEED THE MAXIMUM WATTAGE RATING!). (NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!).

8. Slide the glass (E) into the slots on each side of the fixture body.

IMPORTANT: FIXTURE SHOULD BE INSTALLED BY A QUALIFIED ELECTRICIAN TO ENSURE PROPER WIRING AND INSTALLATION.
Caution , to avoid being burned, wait for the fixture to cool, prior to replacing the light bulbs.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>