GEORGE KOVACS P1301-L LED Pendant Light Instruction Manual

: October 30, 2023
: GEORGE KOVACS

Table of Contents

ASSEMBLING THE FIXTURE (Fig.1 Fig.2)
Read User Manual Online (PDF format)
Download This Manual (PDF format)

GEORGE KOVACS P1301-L LED Pendant Light Instruction Manual

WARNING ! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER

ASSEMBLING THE FIXTURE (Fig.1 Fig.2)

ASSEMBLING THE FIXTURE

Shut off power at the fuse box or circuit breaker. If necessary, remove the old fixture including the mounting hardware.
Carefully remove the fixture from the carton and check that all parts are included as show in Figure 1.
Loosen screws (D) and remove mounting plate (A) from canopy (C). Attach mounting plate (A) (Part# LTG BKT10) to the junction box using mounting screws (B) (size:8-32*1/2″L).
This fixture includes three 12″ and one 6″ rod. Determine the desired hanging height and thread rods F1 (Part#W30-1-655), F2 (Part#W30- 1-655), F3 (Part#W30-H-655) to fixture (G). Pass the wires carefully through each rod during assembly. Next place canopy (C) over rods (F) and thread hanger ball (E) to rod (F). Please remove the nipple if installing with one 6″ rod only.
While holding the fixture body, install the fixture into the mounting plate (A) by tilting at a slight angle so that the hanger ball (E) slips into the mounting plate (A) as shown. Align the notch in the hanger ball (E) to the tab on the mounting plate (A) to prevent the fixture from turning.
CONNECTING THE WIRES (Fig. 3)
t this point, connect the electrical wire as shown in figure 3, making sure that all wire connectors are secured. If your outlet has a ground wire (green or bare copper), connect the ground wire from the hanger ball and mounting plate to it. Otherwise, connect the ground wire from hanger ball directly to the mounting plate ground wire and secure with wire connectors provided. After the wires are connected, tuck them carefully into the ceiling junction box.
FINISHING THE INSTALLATION (Fig.1)
Align canopy (C) over mounting plate (A) and secure with screws (D).
Align glass (H) to the fixture body and secure with finial (I).

Your installation is now complete. Return power to the junction box and test the fixture.

CAUTION/ATTENTION: When handling the fixture, do not apply pressure to the LEDs. Hold the fixture by the base (G) only.

Replacing LED module (Fig. 4)

The LED module can be replaced by a qualified electrician without cutting of wire and without damage to any decorative element to which the fixture is attached.

Warning: Turn off power at the circuit breaker before replacing LED module

a. Loosen finial (I) remove glass (H) and loosen screws (R) remove frame (G)
b. Loosen screws (Q) and remove gasket (M2), glass (P).
c. Loosen screws (J), (N) and remove spacers (O), gasket (M1). Carefully remove LED module (L) from pan (K) and disconnect the wire using screwdriver from wire connector (S).
d. Reverse steps a-c for installing the new LED module.
Note: The LED module should be provided by a specified supplier.

IMPORTANT: Fixture should be installed by a qualified electrician to ensure proper wiring and installation.

Dimmable with ELV and/or LED compatible wall dimmer switches.

a. Hardware Bag:
A. Mounting plate x 1
C. Canopy x 1
D. Screw x 2
E. Hanger ball x 1