GEORGE KOVACS P5044-X-L 20W 1-Light LED Wall Sconce Instruction Manual
- June 13, 2024
- GEORGE KOVACS
Table of Contents
GEORGE KOVACS P5044-X-L 20W 1-Light LED Wall Sconce
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
PREPARATION
- Shut off power at the fuse box or circuit breaker box. If necessary. Remove the old fixture and mounting hardware.
- Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (FIG. 1)
- Secure mounting plate (A) to the outlet box using junction box screws (B) (Size: 8- 32*1/2”L). The side of the mounting plate marked “GND” must face out.
CONNECTING THE WIRES (FIG. 2)
- At this point, connect the electrical wires as shown in Fig. 2, making sure that all wire connectors are secured. If your outlet has a ground wire (green or bare copper), connect the fixtures ground wire to it. Otherwise, connect the fixture ground wire directly to the mounting plate (A) using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
- Place the fixture’s back plate (C) over the mounting back plate (A) and secure with screws (D/SIZE： ‘M4*8MM).
FINISHING THE INSTALLATION (FIG.1)
- Slide the glass shade (H/PG5044) into the front bracket (E). While supporting the glass, attach glass holder (F) to the front bracket (E) with screws (G) to secure the glass in place.
CAUTION/ATTENTION: When handling the fixture, do not apply pressure to the LEDs, Hold the fixture by the base or front bracket (E) only.
IMPORTANT: Fixture should be installed by a qualified electrician to ensure proper wiring and installation. Dimmable with C-L (CFL & LED) type and Incandescent/Halogen type dimmers.
Replacing LED module (Fig. 3)
The LED module can be replaced by a qualified electrician without cutting of
wire and without damage to any decorative element to which the fixture is
attached. See installation steps for more details (Fig 3.)
a. Remove screws (G) Glass holder (F) and glass shade (H).
b. Remove the wire nuts located inside the fixture backplate to
disconnect the LED module.
c. Remove screws (N) on bracket (E). Carefully remove the LED module (I)
from bracket (E),
d. Reverse steps a-c for installing the new LED module.
e. Note: The LED module should be provided by a specified supplier.
f. For better heat dissipation the LED module (I) should be applied with
thermal grease when re-lamping.
Brand : Lutron
Brand : Leviton / Model number : Sureslide 6615
Documents / Resources
|
GEORGE KOVACS P5044-X-L 20W 1-Light LED Wall
Sconce
[pdf] Instruction Manual
P5044-X-L 20W 1-Light LED Wall Sconce, P5044-X-L, 20W 1-Light LED Wall Sconce,
LED Wall Sconce, Wall Sconce, Sconce
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>