Leap Frog IM-608800-000 Big Day Learning Video Game Instruction Manual

June 13, 2024
Leap Frog

Leap Frog IM-608800-000 Big Day Learning Video Game

Instruction Manual
This guide contains important information. Please keep it for future reference.
IM-608800-000 US

INTRODUCTION

Thank you for purchasing the Peppa Pig Peppa’s Big Day learning video game! Join Peppa Pig as she gets ready for school, engages in fun-filled activities at her playgroup, goes on field trips with her classmates and more!Leap Frog
IM-608800-000 Big Day Learning Video Game - Home Button

INCLUDED IN THE PACKAGE

  • 1 wireless controller
  • 1 HDMI game stick
  • 1 micro USB power cable
  • Quick Start Guide

WARNING
All packing materials such as tape, plastic sheets, packaging locks, removable tags, cable ties and packaging screws are not part of thistoy and should be discarded for your child’s safety.
NOTE Please save this Instruction Manual as it contains important information.

GETTING STARTED

Initial Setup

  1. Plug the USB B Connector end of the Micro USB Power Cable into the USB B port on the HDMI Game Stick.
  2. Plug the HDMI Game Stick into an HDMI port on your television.
  3. Plug the USB A Connector end of the Micro USB Power Cable into a USB port on your television.
  4. Make sure your television is set to display the same HDMI port that the HDMI Game Stick is plugged into.
  5. Find the battery cover located on the back of the Wireless Controller, use a screwdriver to loosen the screw and then open the battery cover.*
  6. Remove old batteries by pulling up on one end of each battery.
  7. Install 2 new AA (AM-3/LR6) batteries following the diagram inside the battery box. (For best performance, alkaline batteries or fully charged Ni-MH rechargeable batteries are recommended.)
  8. Replace the battery cover and tighten the screw to secure.
  9. Turn the power switch on the device to On.
  • To ensure proper connectivity, install batteries in the device after the HDMI Game Stick has been plugged into the television.

NOTE
The HDMI Game Stick is only compatible with television sets and is not compatible with computers or computer monitors.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.

IMPORTANT: BATTERY INFORMATION

  • Insert batteries with the correct polarity (+ and -).
  • Do not mix old and new batteries.
  • Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
  • Only batteries of the same or equivalent type as recommended are to be used.
  • Do not short-circuit the supply terminals.
  • To save battery, turn off the controller when finished using it.
  • Remove batteries during long periods of non-use.
  • Remove exhausted batteries from the toy.
  • Dispose of batteries safely. Do not dispose of batteries in fire.
  • Disposal of a battery into fire or a hot oven, or mechanically crushing  or cutting of a battery, that can result in an explosion;
  • Leaving a battery in an extremely high temperature surrounding environment that can result in an explosion or the leakage of flammable liquid or gas.
  • A battery subjected to extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas.

RECHARGEABLE BATTERIES

  • Remove rechargeable batteries (if removable) from the toy before charging.
  • Rechargeable batteries are only to be charged under adult supervision.
  • Do not charge non-rechargeable batteries.
    NOTE
    If the Wireless Controller powers down or if the light fades out during play, please install a new set of batteries.

PRODUCT FEATURES

  1. D-Pad
    • Press the D-Pad on the Wireless Controller to select an item on the Menu screen.
    • See Games section below for D-Pad usage in individual games.

  2. Home Button
    • Press the Home Button on the Wireless Controller to quit a level, quit the game, or return to the previous Menu screen.

  3. Help Button
    • Press the Help Button on the Wireless Controller to hear hints and tips on how to play the game or navigate the Menu screen.

  4. A Button
    • Press the A Button on the Wireless Controller to select the highlighted objects on the Menu screen.
    • See Games section below for A Button usage in individual games.

  5. B Button
    • Press the B Button on the Wireless Controller to return to the previous Menu screen.
    • See Games section below for B Button usage in individual games.

  6. Menu Screens
    • The following Menu screens appear in the game.
    Profile Selection Screen
    • Create or delete a saved profile on the Save Selection screen.
    • If a saved file has been accidentally deleted, highlight a New save slot and press the following buttons on the Wireless Controller: Home + Home + Help + Help + B + B + Help + Home + B. This will also unlock all the missions in the game.
    Game Mode Screen
    • Play games sequentially by selecting Play, or individual games in Quick Play mode.Leap Frog IM-608800-000 Big Day Learning Video Game -
ScreenWeek Menu Screen
    • Access the different games from the Week menu screen.
    • The player will need to get one star in each game in a day before the next day is unlocked.
    Day Menu Screen
    • Select a game within a specific day.
    • Stars earned during gameplay will display below each game’s icon.
    Quick Play Menu
    • Access individual games in the Quick Play menu.

  7. 7. Games
    Game 1: Fix the Path
    • Press the D-Pad to select a piece of the path to fix
    • Press the A Button to turn the piece
    • Press the B Button to send Peppa down the path Game 2: Archery
    • Press the D-Pad up and down to aim at a target
    • Press the A Button to send an arrow towards the target Game 3: Tidying Up
    Searching
    • Press the D-Pad to move the magnifying glass
    • Press the A Button to select an item that’s highlighted by the magnifying glass
    Sorting
    • Press the D-Pad left and right to select a basket
    • Press the A Button to put the item into the basket
    Game 4: Cooking
    • Press the D-Pad down to slice the ingredients
    • Press the D-Pad left and right to stir
    • Press the A Button to add/shake/crack the ingredients
    • Press the B Button to blend the ingredients
    Game 5: Sack Race
    Matching
    • Press the D-Pad left and right to choose the matching sack
    • Press the A Button to select the matching sack
    Racing
    • Press the A Button to make Peppa jump faster
    Game 6: Keepy Uppy
    • Press the D-Pad left and right to move Peppa
    • Press the A Button to jump up
    Game 7: Pirate Island
    • Press the D-Pad up and down to move the boat
    • Press the A Button to speed up the boat
    Game 8: Freeze Dance
    Rhyming
    • Press the D-Pad left and right to select the picture of the word that completes the rhyme
    • Press the A Button to confirm the selection
    Dancing
    • Press the A Button to make Peppa dance
    • Press the B Button to perform a special dance move

  8. Automatic Shut-Off
    To preserve battery life, the Wireless Controller will automatically go into sleep mode after approximately 1 minute without input. The unit can be turned on again by pressing the D-Pad, Home Button, A Button, or B Button.

  9. Screen Saver Mode
    Peppa’s Big Day learning video game will automatically save and quit the current game, then go into Screen Saver mode after approximately 20 minutes without input. To exit Screen Saver mode, press the D-Pad, Home Button, A Button, or B Button on the Wireless Controller.

CARE & MAINTENANCE

  1. Keep the unit clean by wiping it with a slightly damp cloth.
  2. Keep the unit out of direct sunlight and away from any direct heat sources.
  3. Remove the batteries if the unit will not be in use for an extended period of time.
  4. Do not drop the unit on hard surfaces and do not expose the unit to moisture or water.
  5. Always keep the Wireless Controller and HDMI Game Stick away from water.
  6. Examine the Micro USB Power Cable regularly, checking for damage to the cable, plugs and other parts. Do not use a third party adapter.
    Do not use the Micro USB Power Cable if there is any damage.

TROUBLESHOOTING

If you are unable to insert the HDMI Game Stick directly into the HDMI port on your television due to clearance issues, a third-party HDMI extension cable may be a good solution. A short HDMI extension cable can be purchased from major electronics retailers. If for some reason the unit stops working or malfunctions, please follow these steps:
HDMI Game Stick

  1. Interrupt the power supply by unplugging the USB A Connector end of the Micro USB Power Cable from the USB port on your television.
  2. Unplug the HDMI Game Stick from the HDMI port on your television.
  3. Wait for 10 Seconds, then plug the HDMI Game Stick into the HDMI port on your television.
  4. Plug the USB A Connector end of the Micro USB Power Cable into the USB port on your television. The unit will now be ready to play again.

Wireless Controller

  1. Turn off the Wireless Controller with the Power Switch on the back of the controller.
  2. Interrupt the power supply by removing the batteries.
  3. Let the unit stand for 10 seconds, then replace the batteries.
  4. The unit will now be ready to play again.
  5. If the unit still does not work, replace with an entire set of new batteries.

OTHER NOTES
Static electricity may cause the HDMI Game Stick to malfunction. In cases where the HDMI Game Stick is malfunctioning due to static electricity, disconnect the Micro USB Power Cable, wait for 10 seconds, then reconnect the Micro USB Power Cable to reboot the HDMI Game Stick.

FCC Compliance Statement

After completing the steps in the Initial Setup section, power on the television. FCC e-labeling will be shown on the television for the U.S.
version of Peppa Pig Peppa’s Big Day.
This screen confirms that this product complies with FCC regulations.
IMPORTANT NOTE:
If the problem persists, please call our Consumer Services Department at 1-800-701-5327 in the U.S. and Canada, or email support@leapfrog.com. Creating and developing LeapFrog products is accompanied by a responsibility that we take very seriously. We make every effort to ensure the accuracy of the information, which forms the value of our products. However, errors sometimes can occur. It is important for you to know that we stand behind our products and encourage you to contact us with any problems and/or suggestions you might have. A service representative will be happy to help you.
This equipment complies with FCC & Industry Canada radiation exposure limits set forth for an uncontrolled environment.
NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Supplier’s Declaration of Conformity
47 CFR § 2.1077 Compliance Information

Trade Name: LeapFrog ®
Model: 6088
Product Name: Peppa Pig Peppa’s Big Day
Responsible Party: LeapFrog Enterprises, Inc.
Address: 2200 Powell Street, Suite 500,

Emeryville, California 94608
Website:| leapfrog.com

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

  1. This device may not cause interference.
  2. This device must accept any interference, including interference that may cause undesired operation of the device.

CAN ICES-003(B)/NMB-003(B)
RF frequency range and output power
For controller:
Operating frequency Range: 2408-2472MHz
RF output power: -3.70 dBm (max. e.i.r.p.)
For TV Stick:
Operating frequency Range: 2452MHz
RF output power: 3.79 dBm (max. e.i.r.p.)

The terms HDMI, HDMI High-Definition Multimedia Interface, HDMI trade dress and the HDMI Logos are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.

Visit our website for more information about our products, downloads, resources and more.
leapfrog.com
leapfrog.ca
Read our complete warranty and legal policies online at leapfrog.com/legal
LeapFrog Enterprises, Inc.,
a subsidiary of VTech Holdings Limited.
TM & © 2023 LeapFrog Enterprises, Inc.
All rights reserved.
IM-608800-000
Version:0

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Leap Frog User Manuals

Related Manuals