TESLA TH301WR Heater Convector Panel User Manual

June 13, 2024
Tesla

TESLA TH301WR Heater Convector Panel

INTENDED USE

  • This product is mainly designed to heat indoor rooms. It fits on the ground or on a table and features two thermostats, one is for setting function of Off / Fan / Heat I / Heat II, and the other one is to adjust the temperature. The product comes with a number of safety features, including overheat protection and a built-in tip-over switch.
  • It is intended for indoor use only. Do not use it outdoors. Contact with moisture, e.g. in bathrooms, must be avoided under all circumstances.
  • For safety and approval purposes, you must not rebuild and/or modify this product. Using the product for purposes other than those described above may damage the product. In addition, improper use can cause hazards such as short circuits, fire and electric shocks. Read the instructions carefully and store them in a safe place. Make this product available to third parties only together with its operating instructions.

EXPLANATION OF SYMBOLS

The symbol with the lightning in the triangle is used if there is a risk to your health, e.g. due to an electric shock.
This symbol is used to highlight important information in these operating instructions.
Always read this information carefully.
This symbol indicates special information and advice on how to use the product.

IMPORTANT SAFETY INFORMATION

  • Never operate the product in cupboards or other small enclosed spaces.
    This constitutes a fire hazard!

  • Do not place the product directly underneath a wall socket.

  • Do not use the product with a timer, remote switch (e.g. remote-controlled switch socket) or other devices that automatically switch on the product. This may cause a fire if the heater is covered or positioned incorrectly.

  • Never leave the product unattended during use.

  • To reduce the risk of a fire, always leave a space of at least 1.0 m from combustible or flammable materials or objects (e.g. curtains, doors and furniture).

  • Never cover the product! Do not touch the openings on the product or insert objects in the openings, as this may damage the interior components and cause a fire or electric shock.

  • Do not use the product next to a bathtub, shower or swimming pool.

  • Do not allow children to play with the product.

  • The air outlet gets hot very quickly and has the potential to cause skin burns. Exercise caution when handling the product.

  • This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.

  • Children of less than 3 years should be kept away unless continuously supervised.

  • Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its intended normal operating position and they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance.

  • If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.

  • Never place the product on an unstable or moving surface. When positioning the heater, ensure that it cannot tilt or topple over. This may cause a fire or injury or damage the interior components. A safety switch is built into the base of the heater that automatically turns the heater off when it tips over. However, the hot surface still presents a fire hazard.

  • WARNING : Parts of this product may get very hot and cause skin burns. Exercise particular caution when children or vulnerable people are present.

  • Children may only clean or repair the product under the supervision of an adult.

  • WARNING : In order to avoid overheating, do not cover the heater.

GENERAL SAFETY INFORMATION

Read the operating instructions and safety information carefully. If you do not follow the safety instructions and information on proper handling in this manual, we assume no liability for any resulting personal injury or damage to property. Such cases will invalidate the warranty/guarantee.

A) Persons and product

  • This product is not a toy. Keep it out of the reach of children and pets.

  • Do not leave packaging material unattended, as it may become dangerous playing material for children.

  • Protect the product from extreme temperatures, direct sunlight, strong jolts, high humidity, moisture, flammable gases, vapors and solvents.

  • Do not place the product under any mechanical stress.

  • If it is no longer possible to operate the product safely, stop using it and prevent unauthorized use. Safe operation can no longer be guaranteed if the product:
    – is visibly damaged,
    – is no longer working properly,
    – has been stored for extended periods in poor ambient conditions or
    – has been subjected to any serious transport-related stress.

  • Always handle the product carefully. Jolts, impacts, or a fall even from a low height may damage the product.

  • Consult a technician if you are not sure how to use or connect the product.

  • Maintenance, modifications, and repairs must be done by a technician or an authorized repair centre.

  • If you have questions which remain unanswered by these operating instructions, contact our technical support service or other technical personnel.

B) Electrical safety

  • Never pour any liquids over electrical devices or place objects filled with liquid next to the product. If liquid or an object does enter the interior of the device, power down the respective socket (e.g., switch off circuit breaker), and then disconnect the mains plug from the mains socket. Discontinue use and take the product to a specialist repair centre.

  • Never use the product immediately after it has been brought from a cold room into a warm one.
    Condensation may form and destroy the interior components. The power adapter may also cause a fatal electric shock. Allow the product to reach room temperature before connecting it to an appliance. This may take several hours.

  • The mains socket must be located near to the device and be easily accessible.

  • Never unplug the mains plug by pulling on the cable; always use the grips on the plug.

  • Remove the mains plug from the mains socket after use.

  • For safety reasons, unplug the mains plug from the mains socket during thunderstorms.

  • Make sure that the mains cable is not squeezed, bent, damaged by sharp edges or subjected to mechanical stress. Avoid excessive thermal stress on the mains cable from extreme heat or cold. Do not modify the mains cable, as this may damage the interior components. A damaged mains cable can cause a fatal electric shock.

  • Before connecting the product to the mains, check that your local A/C mains voltage matches the specifications on the nameplate.

  • Only power the charger using a standard mains socket (220-240 V/AC, 50 Hz) connected to the public grid.

  • Do not touch the mains cable if it is damaged. Power down the respective mains socket (e.g. via the circuit breaker), and then carefully pull the mains plug from the mains socket. Never use the product if the mains cable is damaged.

  • Damaged mains cables must be replaced by the manufacturer, an authorized repair centre or a qualified electrician.

  • Never insert or unplug the mains plug when your hands are wet.

  • Do not place any objects on the mains cable or allow it to become kinked.

  • Place the mains cable away from open spaces where it will not present a trip hazard. The mains plug must be easily accessible. Do not run the mains cable under a carpet or cover the mains cable with rugs, runners or other materials.

  • Do not use extension cables, ballasts or timer switches. Always insert the mains plug directly into a wall socket.

  • Never use the product without the protective grille. Do not insert objects into the grille.

  • Exercise particular caution in the presence of children. Children do not understand the hazards associated with the incorrect handling of electrical devices. They may attempt to insert objects into the heater, which could cause a fatal electric shock. There is also the risk of a fire or injury due to the hot surfaces.

  • Never use the product in vehicles or other moving spaces. It is only suitable for use in buildings.

  • Only use the product in temperate climates. It is not suitable for use in tropical climates.

  • Before cleaning the product, disconnect the mains plug from the mains socket.

  • You may notice an odour when using the heater for the first time. If so, ventilate. the room.

  • Only move, transport or store the product when it has cooled down completely and you have disconnected it from the mains.

  • This product is not suitable for commercial use.

TECHNICAL DATA

Model| Voltage| Power (W)| Length| Width| Height| N.W.| G.W.
---|---|---|---|---|---|---|---
TH301WR| ~230 V / 50 Hz| 2000W| 21.0 cm| 21.0cm| 62 cm| 1.8 kg| 2.4 kg

PRODUCT OVERVIEW

ASSEMBLING

Take the 2pcs base part out and match them together as pic 1

Take off the screws on the base, and fix back again after the base parts matched as pic 2

OPERATION

A) Setup and connection

  • Place the product on a stable, level surface. It must be placed at least 1.0 m away from walls or other objects to ensure sufficient air circulation. Flammable objects (e.g. curtains) must be at least 1.5 m away.
  • The product is designed to be placed on horizontal surfaces such as floors. It is not suitable for wall mounting. Ensure that the product is level and secure, otherwise the safety switch may be triggered by accident.
  • Turn the power switch to off.
  • Insert the mains plug into a mains socket.

B) Settings

  • Plug in and switch on the heater, then the heater will have a “BI” voice
  • Press On/Off button , the light will be turned on and show P0 in screen. The fan will work.
  • Press setting knob one time, the machine will run on low heating and the display show P1, press again for P2 and The heater will run as P0-P1-P2 in a circle by pressing each one time.
  • Once the setting temperature has been reached, the heater will turn on and off automatically.

C) Oscillation function

  • Press the oscillation button to turn on the swing function and press again to close it .

D) Timer

  • Press timer button and the timer display will be lighted and the screen will flash. Press again, the screen will show 01H, then press timer button again to set timer from 1 hour to 24 hours. Each pressing increase one hour. Show After setting, timer light will be on.

E) Tip-over protection

  • The tip-over safety switch on the bottom of the product automatically cuts off the power supply if the heater tips over.
  • If the product tips over, turn it off and return it to its original position before turning it back on.

F) Overheat protection

  • The heater comes with over heat protection that automatically switches off the heater if it overheats (e.g. if the air outlet is covered). If the overheat protection feature is triggered, follow the steps below:
    – Disconnect the heater from the power supply.
    – Remove the object that is covering the device.
    – Wait for 30 minutes until the product has cooled down to room temperature.
    – Turn on the heater as described above.
    – If the product fails to turn on, contact customer services or a technician.

CARE AND CLEANING

  • Before cleaning the product, check that it is disconnected from the mains and ensure that it has cooled down to room temperature.
  • Do not clean the product with water, as this may cause an electric shock. Do not immerse the product in water!
  • Use a vacuum cleaner to remove dust that accumulates on the air outlet.
  • Never use aggressive detergents, rubbing alcohol or other chemical solutions, as these could damage the casing or cause the product to malfunction.

Disposal

Electrical devices are recyclable waste and must not be disposed of in household waste. Always dispose of the product according to the relevant statutory regulations.
You thus fulfil your statutory obligations and contribute to the protection of the environment.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals