tala ACC-MTL-BTY-01 Mantle Portable Lamp User Guide
- June 13, 2024
- TALA
Table of Contents
User Guide
MANTLE –
REPLACEMENT BATTERIES
The creators of beautiful, sustainable lighting.
Discover the full Tala family at tala.co.uk
PREPARATION
Please read instructions thoroughly before installation and keep them for
future reference.
Improper assembly can undermine the safety and longevity of the product.
IMPORTANT
The product is designed to work with the Mantle Batteries provided. Do not use
alternative batteries as product will not work effectively. For replacements,
visit the Tala website or contact us for assistance.
Avoid turning on product in hot temperatures above 35ºC.
Doing so will reduce lumen output and bulb lifespan.
WARNING
Ensure bulb and PCB are fully installed and base is sealed before exposing to
damp environments and do not allow internal components and surfaces to be
exposed to water.
STEP 1
Ensure the fixture is turned off by pressing the dimmer button at the back of
the fixture until light source is off.
Remove the bulb by screwing anticlockwise until released from the
fixture.
STEP 2
Using a screwdriver, remove the four screws on the underside of the fixture.
Pull back the silicone on the base of the fixture to reveal the internal
construction. Ensure the silicone is completely free from the internal
structure. 
STEP 3
Carefully pull the PCB down and out of the fixture.
Remove the battery covers and the old batteries from the battery clips. Take
care to note the battery orientation.
Replace with the new batteries. Take care to install the new batteries in the
correct orientation. Incorrect orientation will result in damage to the
fixture. Replace the battery covers.
Do not use any other battery than provided by Tala. 
STEP 4
Return the PCB inside the fixture.
Ensure the USB-C socket and LED are located correctly in the silicone
cover.
STEP 5
Re-install the base and screws.
Screw in the bulb until tight. The silicone around the bulb neck is tight to
prevent water ingress, the bulb may need tightened more than expected.
Test the lamp by pressing the dimmer button. The battery indicator light
should illuminate if the PCB is inserted correctly.
If bulb does not turn on at this point, first make sure the bulb is fully
installed in the fixture before re-adjusting the PCB.
CARE AND CLEANING
We recommend cleaning with a soft dry cloth. Do not use abrasive materials as these will damage the finish of the product. Do not use alcohol or other solvents.
Join the Community
Instagram: @tala | Facebook: talaHQ | Pinterest: TalaLED | Tag: lighttoliveby
Tala Studios, 25B Vyner Street, London E2 9DG |
[email protected]
Tala Europe B.V, Bertus Aafjeshove 40, Nieuwegein 3437JN, Netherlands
Tala North America, Inc., 2 Research Place, Suite 300, Rockville, MD 20850,
United States of America