ATOMSTACK E85 Extended Frame User Manual
- June 13, 2024
- ATOMSTACK
Table of Contents
- Packing list
- Assembly of X-axis slide rail assembly and frame
- Cable fixing module installation
- Y-axis limit column installation
- Y-axis timing belt installation
- POM wheel adjustment
- Laser fixed slide rail installation
- Schematic diagram of the wiring position of the mainboard cable
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
**ATOMSTACK E85 Extended Frame User Manual
**
Packing list
Assembly of X-axis slide rail assembly and frame
Cable fixing module installation
Y-axis limit column installation
The stroke of the X-axis is too large. In order to prevent the left-right asymmetry in the assembly of the Y-axis synchronous belt, when the Y-axis synchronous belt is assembled and tightened, the X-axis slide rail assembly should be close to the limit columns at both ends of the Y-axis.
Y-axis timing belt installation
POM wheel adjustment
Judgment and adjustment method of the tightness of the POB wheel on the X-axis slide rail: In the case of ensuring that the support does not shake, one end of the machine can be lifted to 45° from the horizontal plane, and then the X-axis or Y-axis support can be released from a high place. If the bracket slides all the way at a constant speed, then it’s tight enough.
The adjustment state of the POM wheel is from loose to tight cycle, just adjust to the appropriate tightness.
Laser fixed slide rail installation
Dovetail groove laser slide rail
Laser slide rail
Select the laser fixing slide rail according to the laser module Dovetail laser slide rail is compatible with ATOMSTACK 20W/30W laser module Laser slide rail is compatible with ATOMSTACK 10W laser module
Schematic diagram of the wiring position of the mainboard cable
Note:
- The control box is compatible with 12V/24V power adapter.
- When replacing the laser module with different power, you need to replace the supporting power adapter, otherwise the laser module will be damaged!
- After installing the connecting wire, it is necessary to tie the wire to the steel wire of the X-axis and the fixed bracket with a cable tie, otherwise the connecting wire is too long and may scratch the engraved object below.
- For users whose existing laser module has a 4PIN or 3PIN power connector, we provide 5PIN to 4PIN and 5PIN to 3PIN adapter cables, please select the corresponding adapter cable according to the actual situation.
Customer service:
For detailed warranty policy, please visit our official website:
www.atomstack.com
For technical support and service, please email
[email protected]
Manufacturer:
Shenzhen AtomStack Technologies Co.,Ltd
Address:
17th Floor, Building 3A, Phase II, Intelligent Park, No. 76, Baohe Avenue,
Baolong Street, Longgang District, Shenzhen, Guangdong, China
Zip code: 518172
Scan QR code:
QR code reader/barcode scanner or any app with a scanner