UltraPro 50ft LED Rope Light Color Changing Push Button Power User Guide

: June 13, 2024
: UltraPro

Table of Contents

INSTALLATION
OPERATION
LINKING ADDITIONAL ROPE LIGHTS
FUSE REPLACEMENT
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Color-Changing
LED Rope Light
User Manual

Congratulations on your new Jasco Pro Color Changing LED Rope Light! Please read this user manual carefully before using the product. Important features and operating procedures are included in this guide. Please keep the manual in a safe place for future reference.
IMPORTANT: Before installation, please read all the warning statements included at the bottom of these instructions. Save these instructions for later use.

INSTALLATION

INCLUDED HARDWARE

TOOLS REQUIRED

MOUNTING THE ROPE LIGHT
Before installing, make sure that the surface can support the rope light and that the power cord will be in range of an outlet.

Mark the location for each clip (B) and drill pilot holes using a 1/16in. drill bit.
Place the mounting clips over the pilot holes and use a screwdriver to install and tighten each screw (C).
Carefully affix the rope light (A) to each installed clip.
Insert the power plug into outlet.

OPERATION

Repeatedly press the mode-select button to cycle through each color mode.
Single Colors: White, red, green, blue, purple, yellow, cobalt Multi- Color: Mixes all the single-color options together
Twinkle: White lights twinkles throughout the current color
Sparkle: Individual LEDs cycle ON and OFF throughout the current color

LINKING ADDITIONAL ROPE LIGHTS

IMPORTANT: Disconnect the rope light from power before linking any additional strands. You can link up to three strands together in a sequence (maximum 150ft.).

Unscrew and remove the end plug (A) to expose the female connector (B).
Make sure the ring gasket (C) is in place on the female connector.
Plug male connector (D) from next segment into the female connector. Screw compression nut (E) over connection until tight.

FUSE REPLACEMENT

This product employs overload protection (fuse). A blown fuse indicates an overload or short-circuit situation. If the fuse blows, unplug the product from the outlet. Also unplug any additional strings or products that may be attached to the product. Replace the fuse as per the user servicing instructions (follow product marking for proper fuse rating) and check the product. If the replacement fuse blows, a short-circuit may be present and the product should be discarded.

Grasp plug (1) and remove from the receptacle or other outlet device. Do not unplug by pulling on cord. Always unplug this product before installing or replacing fuses.
Slide open the fuse access cover (2) on top of the attachment plug towards blades (3).
Remove fuse (4) carefully. Push the fuse from the other side.
Risk of fire. Replace fuse only with 3 Amp, 125 Volt fuse (provided with product).
Close fuse cover (2). Close the fuse access cover on top of attachment plug.
Risk of fire. Do not replace attachment plug as it contains a safety device (fuse) that should not be removed. Discard product if the attachment plug is damaged.

WARNING

DO NOT MOUNT OR SUPPORT FLEXIBLE LIGHT IN A MANNER THAT CAN DAMAGE THE OUTER JACKER OR CORD INSULATION.
RISK OF FIRE AND ELECTRIC SHOCK. UNCOIL FLEXIBLE LIGHT PRIOR TO PLUGGING IN. DO NOT USE WITH EXTENSION CORD NEAR WATER MAY ACCUMLATE. FOR USE ONLY ON GFCI PROTECTED CIRCUITS.
MATERIAL MAY BECOME BRITTLE WHEN COLD. DO NOT INSTALL WHERE IT MAY BE STEPPED ON OR SUBJECT TO PHYSICAL DAMAGE.
DO NOT INSTALL NEAR FLAMMABLE LIQUIDS.
DO NOT INSTALL CLOSER THAN 3 METERS FROM A SWIMMING POOL SURFACE.
ALWAYS UNPLUG THIS PRODUCT BEFORE INSTALLING OR REPLACING FUSES. USE ONLY 125-VOLT, 3 AMP MAX.
DO NOT COVER FLEXIBLE LIGHT AS THE COVERING MAY CAUSE THE FLEXIBLE LIGHT TO OVERHEAT AND MELT OR IGNITE.
TO PREVENT OVERHEATING, DO NOT ALLOW CONTACT BETWEEN FLEXIBLE LIGHT CABLES OR PARTS OF THE FLEXIBLE LIGHT CABLE. MAINTAIN AT LEASE 10MM (0.39IN) SPACING BETWEEN LIGHT CABLE OR LIGHT CABLE PARTS.
NOT SUITABLE FOR FIELD CUTTING OR SPLICING.
DO NOT OVERLOAD. DO NOT CONNECT TOGETHER MORE THAN 150 TOTAL FEET.

THANK YOU FOR YOUR PURCHASE!

Instructions made easy
Read instructions or watch easy-to-follow video.
Scan code or visit byjasco.com/54507i
Scan code or visit byjasco.com/67117i

Exclusion deals
For deals, to register your purchase and to tell us how
we’re doing, simply scan the code or visit byjasco.com/deals
Discover more innovative lighting at byjasco.com/lighting

Like our product?
Leave a review on your favorite retailer website or amazon.com
Having problems?
Let us know how we can help.
Call 1-800-654-8483 between 7AM-8PM, M-F, Central Time.

MADE IN CAMBODIA
Distributed by Jasco Products Company LLC, 10 E. Memorial Rd., Oklahoma City, OK 73114.
This Jasco product comes with a 3-year limited warranty. Visit www.byjasco.com for warranty details.
Questions? Contact our U.S.-based Consumer Care at 1-800-654-8483 between 7AM-8PM, M-F,
Central Time.byjasco.com/recycle
©JASCO 2021 | 67117, 67118, 67121 | 10/21 v1